Assembly - Delta AP300 Instruction Manual

ASSEMBLY TOOLS REQUIRED
1. 1/2" & 9/16" Open or Box End Wrench
2. 1/2" & 9/16" Socket and Drive - not provided
ASSEMBLY TIME ESTIMATE 1-2 hrs.
CASTERS
1. Place the dust collector on its side.
2. Insert bolt on caster through the four holes (A)
Fig. 3 in the base of the dust collector.
3. Thread a 3/8-16 flange hex nut (B) Fig. 4 onto each
of the four bolts and tighten securely.
EXHAUST FLANGE
1. Align the holes in the exhaust flange (A) Fig. 5 with
the holes in the exhaust flange gasket (B).
2. Insert a 5/16-18x5/8" hex head bolt thru the exhaust
flange, exhaust flange gasket and the base unit as
shown in Fig. 6.
3. Thread a 5/16-18 hex nut (B) onto the 5/16-18x5/8"
hex head bolt (A) Fig. 6 and tighten securely.
4. Repeat this process for the three remaining bolts.

ASSEMBLY

- not provided 3. Flat or Phillips Screwdriver
9
- not provided
A
Fig. 3
Fig. 4
B
A
Fig. 5
A
Fig. 6
B
B