Heinner HWM-VT2104IVKA+++ Manual page 7

www.heinner.com
V. INSTALATION
REMOVING THE TRANSIT BOLDS
1. Before operating the washing machine, remove the 4 transportation screws and rubber
spacers from the back of the machine. If the screws are not removed, it may cause heavy
vibration, noise and product malfunction, (voiding the guarantee).
2. For this reason, transportation safety screws shall be loosened by being rotated in
counterclockwise using an appropriate wrench.
3. Transportation screws shall be removed by pulling out.
4. Fit the plastic transportation screw taps delivered in accessories bag to the places where
transportation screws have been removed.
5. The transportation safety screws should be stored to be used in case of transportation.
NOTE: You should absolutely remove the transportation screws of your machine
before the first usage. Faults occurring in the machines operated with transportation
screw fitted shall be out of scope of warranty.
ADJUSTMENT
Do not install your machine on a carpet or such grounds that would prevent the ventilation of its
base. To ensure silent and vibration-free operation of your machine, it should be deployed on a
non-sliding and firm ground. You can adjust the balance of your machine through the stays.
Loosen the plastic adjustment nut.
7