Supermicro SuperServer 1025C-3 User Manual page 82

S S
UPER ERVER 1025C-3 User's Manual
PCI Confi guration
Access the submenu to make changes to the following settings for PCI devices.
Onboard GLAN-1/Onboard GLAN-2 (Gigabit- LAN) OPROM
Confi gure
Select Enabled to allow the system to boot from the GLAN-1 connection or the
GLAN-2 connection. The options are Disabled and Enabled.
Reset Confi guration Data
If set to Yes, this setting clears the Extended System Confi guration Data- (ESCD)
area. The options are Yes and No.
Slot1 PCI 33MHz, Slot2 PCI 33MHz, Slot3 PCI 33MHz, Slot4 PCI-Exp.
x4, Slot5 PCI-Exp. x8, and Slot6 PCI-Exp. x8
Access the submenu for each of the settings above to make changes to the
following:
Option ROM Scan
When enabled, this setting will initialize the device expansion ROM. The options
are Enabled and Disabled.
Enable Master
This setting allows you to enable the selected device as the PCI bus master.
The options are Enabled and Disabled.
Latency Timer
This setting allows you to set the clock rate for Bus Master. A high-priority, high-
throughout device may benefi t from a greater clock rate. The options are Default,
0020h, 0040h, 0060h, 0080h, 00A0h, 00C0h, and 00E0h. For Unix, Novell and
other Operating Systems, please select the option: other. If a drive fails after
the installation of a new software, you might want to change this setting and
try again. A different OS requires a different Bus Master clock rate.
Large Disk Access Mode
This setting determines how large hard drives are to be accessed. The options are
DOS or Other (for Unix, Novelle NetWare and other operating systems).
7-10