solarcentre BRIGHTON User Manual

BRIGHTON
SOLAR GARDEN LIGHT (SET OF 2)
W E
S
Ensure your solar
panel is South facing
or as near as possible
Thank you for choosing the Brighton Solar Garden Lights. Please read these instructions carefully
Important notes
Always take care when installing your light. If you are at all unsure, please contact your retailer or a professional trades person for
advice.
Installation
Remove all packaging and put to one side. Please carefully consider where you wish to install your light before making alterations
to your property. It's particularly important that the solar panel receives as much sunlight as possible. Ensure that it is not
obstructed by buildings, fences, trees, sheds, etc, or the shadows that these create. If the solar panel is installed in a poor
location, it may not perform to the best of its ability.
To maximise the battery capacity, the lights should be charged in direct sunlight for at least 12-24 hours before being used for
the �rst time.
The lights will turn ON/OFF automatically when left in the on position. Please note it is completely normal for the lights to come
on at di�erent times as it depends on how fast they charge in their location.
Assembly
Attach the pointed ground stake to the bottom of the pole and simply place into soft ground.
Twist the lamp shade and locate the on/o� switch. Push the button once to switch the light ON.to enable automated lighting at
dusk and dawn. Replace the cover and position the light in a sunny location. Please note for the solar panel to charge, the lights
must be kept in the ON position.
Troubleshooting
Please ensure that there are no nearby light sources shining on the solar panel after dark. These could be bright indoor/outdoor
lights from your property or neighbours, or streetlights.
If you are unsure, take the light inside and test it in a dark room.
If you are encountering any problems with your Brighton Garden Lights often you can resolve this yourself by following our
troubleshooting guide. If the light has it's solar panel in a poor location it will struggle to work, but that doesn't mean there is a fault
with the unit. Please remember that the light will arrive with some charge and will likely work for a few days even if the solar panel is
poorly located. Please try the troubleshooting tips below before contacting your retailer.
Recharge Procedure
1. Double check the location of your solar panel to ensure it is in a clear location and as South facing as possible.
2. Turn the light off at the switch and leave it to recharge for 3-5 days ensuring one sunny day has passed.
3. After 3-5 days return to the light and turn it back on at the switch.
4. If your light still does not illuminate after dark, please contact your retailer.
Clean your solar
panel from time
to time
before using your light.
USER GUIDE
Do NOT place your
solar panel in shaded
areas.
Do NOT charge
behind glass