solarcentre MINI LONDON SC2326 User Manual

MINI
MINI LONDON
USB SOLAR POST LIGHTS (SET OF 4)
SOLAR XT POST LIGHTS (SET OF 4)
- ANTHRACITE EDITION
W E
S
Ensure your solar
panel is South facing
or as near as possible
Thank you for choosing the Mini London USB Solar Post Lights. Please read these instructions
Thank you for choosing the London Solar Post Lights. Please read these instructions carefully be
Important no tes
Always take care when installing your light. If you are at all unsure, please contact your retailer or a professional trades person for
advice. Always take care when setting up your London Solar Post Lights if the ground is very hard - sometimes watering the
ground a little and allowing it to soak in can make it easier to put the spike in.

Installation

Remove all packaging and put to one side. Please carefully consider where you wish to install your light before making alterations
to your property. It's particularly important that the solar panel receives as much sunlight as possible. Ensure that it is not
obstructed by buildings, fences, trees, sheds, etc, or the shadows that these create. If the solar panel is installed in a poor
location, it may not perform to the best of its ability.
1. If required, soften the ground with water, before pushing the spike gently into the ground
2. Remove the protective �lm from the solar panel if present - this will be obvious if necessary
1. If required, soften the ground with water, before pushing the spike gently into the ground
2. Remove the protective �lm from the solar panel if present - this will be obvious if necessary.

Charging your London Solar Post Lights:

Now you have assembled and positioned your light, you need to charge it up prior to use. Gently ease the top of the light o� by
pulling it upwards. Locate the switch which is situated on the underside of the top of the light. Ensure that the switch is turned on
Now you have assembled and positioned your light you need to charge it up prior to use. Gently ease the top of the light o� by pulling
and leave the light for 3 days to build up a base charge.
it upwards. Locate the switch which is situated on the underside of the top of the light. Ensure that the switch is turned o� and leave
the light for 3 days to build up a base charge.
Please repeat this charging process if your light runs low on charge at any time or doesn't appear to be staying on after dark for as
long as expected.

USB-C Charging

To charge the light via USB-C, locate the USB-C charging port on the underside of the solar panel. You can take your light inside
Using your London Solar Post Lights:
to charge via a USB -C cable (included).
1. Remove the stainless steel top from the white plastic light di�user.
2. Put the top upside down (solar panel down) in a dark room and select the S (standard) or P (Powersaving best for winter) setting.
The light will turn o� when you �ip the top back over when light hits the solar panel as the panel will begin charging the battery again.
1. Remove the top from the white plastic light di�user.
3. Put the top back on the di�user. When dusk falls the light will activate automatically.
2. Put the top upside down (solar panel down) in a dark room and locate the switch to turn the light ON.
3. Choose your desired lighting output (white or warm white) via the 3-way switch.
The lights will turn ON/OFF automatically when left in the on position (S or P setting). Please note it is completely normal for the
lights to come on at di�erent times as it depends on how fast they charge in their location.
The light will turn o� when you �ip the top back over when the light hits the solar panel as the panel will begin charging the battery
again.
4. Put the top back on the di�user. When dusk falls the light will activate automatically.
Clean your solar
panel from time
to time
carefully before using your light.
using your light.
USER GUIDE USER GUIDE
Do NOT place your
solar panel in shaded
areas.
Do NOT charge
behind glass
fore