solarcentre LANCASTER User Manual

LANCASTER
SOLAR TABLE LAMP
W E
S
Ensure your solar
panel is South facing
or as near as possible
Thank you for choosing the Lancaster Solar Table Lamp. Please read these instructions carefully
Important notes
Always take care when installing your light. If you are at all unsure, please contact your retailer or a professional tradesperson for
advice.

Installation

Remove all packaging and put it to one side. Please carefully consider where you wish to install your light before making
alterations to your property. It's particularly important that the solar panel receives as much sunlight as possible. Ensure that it is
not obstructed by buildings, fences, trees, sheds, etc, or the shadows that these create. If the solar panel is installed in a poor
location, it may not perform to the best of its ability.
To maximise the battery capacity, the lights should be charged in direct sunlight for at least 8 hours before being used for the �rst
time.
The lights will turn ON/OFF automatically when left in the on position. Please note it is completely normal for the lights to come
on at di�erent times as it depends on how fast they charge in their location.

How to use

We recommend charging the solar lamp in the daylight for a minimum of 8 hours before you �rst switch it on.
Press the ON/OFF switch on the side of the metal body for 3 seconds to switch to on or o�. Please note for the solar panel to
charge, the lights must be kept in the ON position.
White R ing: Normal Working
1
Blue R ing: Standby Mode
2
R E D R ing: Charging Mode
3
Green R ing: Full Charged Mode
4
Clean your solar
panel from time
to time
before using your light.
ON OFF
3sec 3sec
USER GUIDE
Do NOT place your
solar panel in shaded
areas.
Do NOT charge
behind glass