Page 2
This Quick Start Guide is intended to help you set up your hot tub quickly and easily. Use the camera on your smartphone to scan the QR code below or visit www.hotspring.com to find a digital copy of: Test Your Fill Water •...
Page 3
TEMPERAT Set the Water Temperature BALANCE- Balance Your Water Use the control panel to set the temperature to your desired Dip a FreshWater 5-Way Test 5-WAY TEST STRIP level, which should be at least 95°F (35°C). We recommend Strip into the water for two temperatures between 100°F (38°C) and 104°F (40°C).
Using the Control Panel Maintenance Tips Touch anywhere on the screen to turn on the control panel. See your spa's full Owner's Manual for more information on using your control panel. Protect your investment for years to come with these important tips.
IMPORTANT SAFETY INSTRUCTIONS READ ALL OF THIS INFORMATION BEFORE USING YOUR SPA Safety Information • Do not connect any auxiliary components (for example, cable additional speakers, headphones, additional audio components) to the audio system unless approved by WATKINS WELLNESS . •...
Page 6
• Persons taking medications which induce drowsiness, such as DANGER - RISK OF ELECTRICAL SHOCK tranquilizers, antihistamines, or anticoagulants should not use the spa. • Install at least 5 feet (1.5 m) from all metal surfaces. A spa may be installed within 5 feet (1.5 m) of a metal surface if each metal surface HEALTH PROBLEMS AFFECTED BY SPA USE is permanently connected by a minimum No.
SPA SHELL AVOIDING THE RISK OF SKIN BURNS Your HOT SPRING spa has an acrylic shell. Stains and dirt generally will not adhere to your spa’s surface. A soft rag should easily remove • To reduce the risk of injury, before entering a spa the user should most dirt.
Electrical Requirements supply power to the spa. • The subpanel requires a 50 amp, single phase, 230 volt, four wire IMPORTANT: Fill the spa with water before turning on the power. service (two line, one neutral, one ground). The grounding conductor must not be less than #10 AWG.
SOVEREIGN (IIN), PRODIGY (HN) & JETSETTER LX (JTN) 230 volt permanently connected model WARNING! THE EXACT PHYSICAL LOCATION OF THE TERMINALS ON THE GFCI BREAKER WILL VARY BETWEEN MANUFACTURERS. CONNECTING THE HOT WIRE TO THE NEUTRAL TERMINAL WILL CAUSE IRREVERSIBLE DAMAGE TO THE CONTROL BOX. FACTORY WIRED HEATER...
waterproof cover, the outlet should be no closer than 6 feet (1.8 meters) Required Part: A Subpanel (230 volt Convertable) available from your and no farther than 10 feet (3 m) from the spa (reference National HOT SPRING dealer. Electrical Code). 1.
Page 11
JETSETTER (JJN) 230 volt converted model IMPORTANT! The exact physical location of the terminals on the GFCI breaker will vary between manufacturers. Connecting the hot wire to the neutral terminal will cause irreversible damage to the control box. 230V, 50 Amp, 2-POLE, CIRCUT BREAKER (NON GFCI)
Need help?
Do you have a question about the HIGHLIFE SOVEREIGN and is the answer not in the manual?
Questions and answers