Preparation; How To Attach/Detach The Faceplate; How To Reset Your Unit; How To Prepare The Remote Controller - Kenwood KDC-348U Instruction Manual

Preparation

How to attach/detach the faceplate

1
2
■
Do not expose the faceplate to direct
sunlight, excessive heat, or humidity. Also
avoid places with too much dust or the
possibility of water splashing.
■
Keep the faceplate in its casing while
detached.
■
The faceplate is a precision piece of
equipment and can be damaged by shocks
or jolts.
■
To prevent deterioration, do not touch the
terminals of the unit and faceplate with your
fingers.

How to reset your unit

If this unit fails to operate
properly, press the reset
1
button.
The unit returns to factory
2
settings when the reset
button is pressed.
3
Reset button
4
English
How to prepare the remote
controller (RC-405)
When you use the remote controller for the
first time, pull out the insulation sheet.
1
2
If the effectiveness of the remote
controller decreases, replace the battery.
¤ Caution:
■
Do not set the remote control in hot places
such as on the dashboard.
■
Lithium battery.
Danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
■
The battery pack or batteries shall not be
exposed to excessive heat such sunshine,
fire or the like.
■
Keep battery out of reach of children and in
original package until ready to use. Dispose
of used batteries promptly. If swallowed
contact physician immediately.
CALIFORNIA, USA ONLY
This product contains a CR Coin Cell Lithium
Battery which contains Perchlorate Material –
special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/
perchlorate
Insulation sheet
4
2
3
1