Festive P035806 Instructions

These instructions are for your safety. Please read them thoroughly before use and retain for future
reference. Please see the additional information on the base/ cable label.
Before You Start - No tools required for assembly.
Make sure that you have plenty of space and a clean dry place for assembly.
•
Always try to assemble the product as close as possible to the intended location.
•
• Remove all plastic bags and dispose of safely.
Positioning Instructions
1) This Fibre Optic Tree is for INDOOR USE ONLY.
2) Do not position or place near heaters or any other direct sources of heat.
3) Always position cables and extension leads so that they will not be a hazard to the elderly, pets and
children.
4) DO NOT position this product where it may be covered by other items e.g. curtains, nets or bedding or
tree skirts.
5) The mains transformer MUST be located INDOORS.
6) This product is suitable for positioning on surfaces which have normal flammability e.g. wood,
plasterboard, and masonry. However this does not include highly flammable surfaces (e.g. polystyrene,
textiles).
7) Place tree on a level surface. Do not place on long pile carpet, as this may affect stability and interfere
with the ventilation of the base. Do not cover the ventilation holes in the base.
8) This product is not designed for permanent or long-term use.
Assembly
1) Carefully insert the supporting feet into the LED tree base hub along the corresponding groove, as fig 1.
2) Please ensure that each foot clicks firmly into place. See Fig 2.
3) Connect the output cable from the foot of the tree to the transformer, using the power cable provided as
fig 3.
4) Shape tree by arranging branches to create a full and natural look.
5) Connect the transformer into mains supply.
6) The tree will light up; the colour will change and shimmer & some LEDS flash, others twinkle.
The LEDs on this tree are non-replaceable under normal conditions. If a bulb fails the remaining bulbs
should remain alight providing the defective bulb is undamaged.
Warning
This tree is intended for INDOOR USE ONLY.

IMPORTANT – DO NOT LOOK DIRECTLY INTO THE LED

This product contains NON- REPLACEABLE LED. Do not attempt to replace them.

Do not connect this product electrically to another product.

Never allow any part of the set to meet a source of heat or flame.

fig.1 fig.2
TYPE
P
035806
120CM 4LEG
QSF1001
fig.3