Festive WELLD QSF1001 Assembly, Use And Care Manual

Assembly, Use and Care Instructions for:
These instructions are for your safety.
Please read them thoroughly before use and retain for future reference.
Before You Start
• Decide on an appropriate location for your product (see positioning instructions below).
Remove all plastic bags and dispose of safely out of the reach of children & animals.
•
Check the light set before use for any loose or damaged wiring. If in any doubt do not use
•
Retain the instructions for future use.
•
Please note, it is recommended that two people assemble this item.
•
Positioning Instructions
1) Please refer to the cable label affixed to the product to establish its positioning suitability.
2) Do not position or place near heaters or any other direct sources of heat.
Assemble the base stand.
Metal Folding and Basket Stands
(If your tree has a basket stand only follow step 3)
1) Open the stand to form an "X" shape.
2) Ensure the holes in the stand line up with the
holes in the legs.
3) Insert the three bolts & screw in– do not
fully tighten the screws at this stage.
All trees
1) Remove any protective plastic end caps from ends of the tree sections and store in the storage
carton.
2) Insert the bottom section of the tree into the stand. One person needs to hold the tree upright
whilst the other person tightens the 3 bolts in the stand to hold the tree firmly in place (if
applicable).
3) Check that the tree is upright and not leaning. If so, undo the screws & repeat the operation.
4) Remove the band that holds the bottom branches together (if applicable). The branches should
lower into place. Make sure that all of the branches are lowered completely.
unnecessary force.
5) Do not connect the plug to the power supply at this stage.
6) Place the middle section on top of the bottom section & remove the band that secures the branches
(if applicable). Make sure that all of the branches have lowered properly.
7) Connect the lighting chains that link the bottom and middle sections by locating the key or arrow on
the male connector and the groove or arrow on the female connector and push both connectors
together firmly. To secure the connection tighten the threaded collar securely.
8) Place the top section on top of the middle section & remove the band that secures the branches.
9) Connect the lighting chains that link the middle and top sections be repeating step 7.
P051059, P051060
WELLD
Plastic Base with Leg Inserts
1) Carefully invert the tree base and slide each
leg into the corresponding slot on the tree
base.
2) The legs should be a tight fit to ensure
stability.
TYPE
QSF1001
.
Do not use