Festive P049888 Assembly And Usage Instructions

Assembly and Usage Instructions for
P049888- 120cm micro dewdrop gold tape tree – 600 traditional warm white
P049889- 150cm micro dewdrop gold tape tree - 1000 traditional warm white
P049890- 180cm micro dewdrop gold tape tree - 1500 traditional warm white
BOX CONTENTS
1 x tree base
1 x Transformer
1 x micro dewdrop tree (can be 1 part or 2 parts depending on size of the tree.)
3 x outdoor stakes.
ASSEMBLY INSTRUCTIONS
All trees:
(Please note as due to different sizes, there could be a different amount of tree sections, so please follow the below but you
will not need to connect the 2 tree parts together for the 120cm tree, as this only comes in 1 x tree piece)
1) Check that you have all pieces and parts before continuing.
2) Attach the bottom tree section to the base of the tree by screwing the section into the base in a clockwise direction.
3) Attach the top section of the tree to the bottom section of the tree by pushing them together.
4) Next you will see a connector attached to the bottom of the top section & attached to the top of the bottom section,
you will need to screw these together, they will only fit one way, so take note of the inside shape of each connector
and match up.
You may now plug the tree into the power supply and stand back and admire your efforts.
Positioning Instructions
1) Please refer to the cable label affixed to the product to establish its positioning suitability.
2) Do not position or place near heaters or any other direct sources of heat.
WARNINGS
It is very important that this product is NEVER DIRECTLY connected to the mains supply without the supplied transformer.
Keep away from children & pets.
Do not operate this item whilst still in the packaging.
The LED lamps are not replaceable.
The transformer is only suitable for indoor use.
Do not try to connect this set electrically to another set.
If there is any damage or breakage to the electric wire, please dispose of safely.
Ensure that cables are fully unwound and sited where they will not become damaged or present a tripping hazard.
Do not secure the wiring of this product with staples or nails.
Do not close doors or windows on the product, as this may damage the wiring insulation.
Do not submerge this product in water (e.g. puddles, guttering or ponds)
Do not overload wall sockets. Use different sockets around the house to plug in multiple lights to balance the load.
Do not damage the insulation of cable or LED holder.
Do not lay the cable under carpet or where it can be damaged.
Do not completely cover the LED with decorations & other flammable materials. Ensure adequate airflow around each LED.
MICRO DEWDROP LED TREE
TYPE
Micro dewdrop tree
QSF1003