Maintenance - Exide MOTION+ PREMIUM SP3 Operating Instructions Manual

• Fault 6 may occur if the charger is in an ambient temperature above 35°C or airflow is
restricted. Charge stops under these conditions until the charger has cooled sufficiently.
• Fault 7 will occur if there is a problem with the internal configuration file
• Fault 8 will occur if the optional safety disconnect system wiring is damaged.
Warnings do not affect the charge procedure.
No. of RED flashes
11
12
• Warning 11 indicates that the battery might be at fault or have been over discharged. This
fault code will be shown every 10 seconds.
• Warning 12 will occur if the battery has been disconnected from the charger, without the
pause button being pressed.
7 Repair
This product is not user serviceable. To prevent electric shock, the case must not be
removed.
In the event of a problem occurring please contact your local Service Department.
8

Maintenance

Before carrying out maintenance, isolate the mains supply and disconnect the bat-
tery.
Only suitably qualified personnel should perform maintenance work on this equip-
ment.
The charger will require little maintenance, but the following schedule is recommended once
a month:
(a) Check the condition of all cables, paying particular attention to the points where cables
may be severely flexed, i.e. at the entry to charger cabinet, charging plugs and sockets.
(b) Check condition of charging plugs and sockets for wear and any evidence of overheat-
ing, which could ultimately
lead to charger malfunction.
(c) Check that ventilation is not obstructed.
(d) Ensure that all safety covers and panels are correctly in place.
6
Warning
Sulphated battery
Battery disconnected during charge
Repair