Advertisement
Advertisement
Table of Contents
Related Manuals for Exide 12/7
Summary of Contents for Exide 12/7
-
Page 1: User Guide
USER GUIDE 12 V Lead acid batteries 1-150 Ah... - Page 2 Read the safety instructions and user guide carefully. If you follow the instructions, you will benefit from a high-performance charger that will give excellent service for many years to come. For more information about Exide and our products, please visit: www.exide.nu www.tudor.se...
-
Page 3: Getting Started
GETTInG STARTED 1. connect the charger’s mains plug to a power socket. 2. connect the charger’s red cable clamp to the battery’s positive ter- minal post (+), and the black cable clamp to the battery’s negative terminal post (-). 13,7V 3. - Page 4 USER GUIDE (Read through the instructions before use): 1. Read the safety notes and take the stated precautions. 2. Connect the charger’s mains plug to a power socket. The lamp on the front of the charger shine. 3. Connect the charger’s red cable clamp to the battery’s positive terminal post (+), and the black cable clamp to the battery’s negative terminal post (-).
-
Page 5: Safety Notes
SAfETy noTES • The charger has been constructed to charge 12 V lead acid batteries or to act as a power supply for 12 V equipment. Do not use the charger for other purposes. • Do not use the charger if its cables, terminal clamps or casing are damaged. -
Page 6: Description Of Functions
DEScRIpTIon of fUncTIonS The charger is fully automatic and programmed for advanced charging of lead-acid batteries between 1 and 150 Ah. The integrated safety functions that are intended to limit overcharging could interrupt the charge process when charging larger batteries. This applies especially when charging batteries that are larger than approx. -
Page 7: Fault Indications And Troubleshooting
type of battery, the charger is equipped with a cut-out function that interrupts charging, at the same time as the fault is shown by the LED lighting constantly red. NOTE: This fault alarm can be trig- gered during charging of batteries that have capacities above the recommended battery size, or in connection with other equipment drawing current (parallel loads) being connected to the battery during charging. -
Page 8: Maintenance/Accessories
Probable cause 2: Parallel load. If a piece of equipment that drains current is connected to the battery, there is a risk that the capacity of the charger is not sufficient to charge the battery within the time constraints that are built into the charger for safety reasons. Action: If possible, disconnect the parallel load and repeat charg- ing, or purchase a larger charger suitable for both charge and drain. -
Page 9: Technical Specifications
TEchnIcAL SpEcIfIcATIonS Model: EXIDE 12/7 EXIDE 12/7 is a primary-switched computer-controlled charger Input voltage 220-240 VAC +/-10% Input current 1,5 A Back current ≤1mA Charging current 13,7 – 15,5 VDC at 25ºC Charging current Supply 13,7 VDC Charging current Max 7 A... -
Page 10: Warranty
The guarantee will no longer be valid if the charger has not been handled correctly, or opened or repaired by any other than Exide Technologies or its authorized representatives. Exide Technologies is not responsible for other costs than those stated above, i.e.