Semi-Permanent Installation - DeLonghi PAC-A130HPE User Manual

Semi-permanent installation

SEMI-PERMANENT INSTALLATION
If required, your appliance can also be
installed semi-permanently (Fig. E).
11,8 in
30 cm
Proceed as follows:
• Drill a hole ø 5,25 inches (ø 134 mm) in an
outside wall or through a window pane.
Respect the dimensions and height of the
hole given in figure F and G.
in the win- in the wooden
dow pane kickboard of
a French win-
dow
F
"As special tools are required for installa-
tion, we suggest you have the applian-
ce installed by specialized personnel."
6
11,8 in
30 cm
E
in the wall: it is
recommended
that you insulate
a section of the
wall using suit-
able insulation.
• Fit the wall flange
• Fit the air exhaust hose
exhaust hose housing
rear side of the appliance (fig. A page 5).
• Fit the end of the hose
11
flange as shown in fig. G.
12
When the hose
drilled hole can be closed with the flange
11
cap .
NOTE: When installing the air conditioner
semi-permanently, you should leave a door
slightly open as little as 1/2 " (1 cm) to guar-
antee correct ventilation and room pressure.
Keep the exhaust hose as short and free
of curves as possible to avoid constric-
tions.
11
into the hole.
12
into the air
8
located on the
12
to the wall
G
MAX100 cm
MAX 39,37 inches
MIN 35 cm
MIN 13,77 inches
is not connected, the