Compaq d338 - Microtower Desktop PC Management Manual page 40

Desktop Management Guide
✎
36
If two selections are available, go to step 7.
7. Use the up or down arrow key to move to Reset to Factory
Settings—Do Not Reset. Press the left or right arrow key once.
A message is displayed stating: Performing this action will reset
the embedded security device to factory settings if settings are
saved on exit. Press any key to continue.
Enter
Press .
8. The selection will now read Reset to Factory Settings—Reset.
F10
Press to accept the change.
9. Use the left or right arrow key to move to File. Use the up or
down arrow key to move to Save Changes and Exit. Press
Enter
, then press
10. Restart the computer.
F10
11. Press the key as soon as the monitor light turns green.
If you do not press the
the computer off, then on again, and press the
access the utility.
12. Type the Setup password, then press
13. Use the up or down arrow key to select a language, then press
Enter
.
14. Use the left or right arrow key to move to the Security tab, then
use the up or down arrow key to move to Embedded Security
Enter
Device. Press
15. If the selection in the dialog box is Embedded Security
Device—Disable, use the left or right arrow key to change it to
Embedded Security Device—Enable. Press
16. Use the left or right arrow key to move to File. Use the up or
down arrow key to move to Save Changes and Exit. Press
Enter
, then press
www.hp.com
F10
to confirm.
F10
key at the appropriate time, you must turn
Enter
.
F10
to confirm.
F10
key again to
.
F10
.
Desktop Management Guide