Midea MRU21C7BST User Manual page 11

Leveling Feet
To avoid vibration, the appliance must be
leveled.
If required, adjust the leveling feet (located on
both sides of the bottom front) to compensate
for the uneven floor.
The front should be slightly higher than the rear
to aid in door closing.
Leveling feet can be turned easily by tipping the
cabinet slightly.
Turn the leveling feet clockwise
unit, or counterclockwise
Moving the Appliance
1. Remove all items from the appliance.
2. Pull the power plug out, insert and fix it
into the power plug hook at the rear or on
top of the appliance.
3. Tape parts such as shelves and the door to
prevent from falling off while moving the
appliance.
4. Move the appliance with more than two
people carefully. When transporting the
appliance over a long distance, keep the
appliance upright.
ATTENTION
Before making changes, the refrigerator
must be disconnected from power.
Precautions should be taken to prevent any
personal injury.
Replacing the light
Any replacement or maintenance of the
LED lamps is intended to be made by the
manufacturer, its service agent or similar
qualified person.
Tips for Energy Saving
Do not place the appliance near cookers,
radiators or other heat sources. If the ambient
temperature is high, the compressor will run
more frequently and for longer, resulting in
increased energy consumption.
Ensure that there is sufficient ventilation at
the base of the appliance, on the sides of the
appliance and at the back of the appliance.
Please also observe the spacing dimensions in
the chapter "Installation".
to raise the
An evenly filled refrigerator/freezer compartment
to lower it.
contributes to optimal energy use.
Allow warm food to cool before placing it in the
refrigerator/freezer compartment. Food that has
already cooled down increases energy efficiency.
Allow frozen food to defrost in the refrigeration
compartment The coldness of the frozen
food reduces the energy consumption in the
refrigerator compartment and thus increases the
energy efficiency.
Open the door only as briefly as necessary to
minimise cold loss. Opening the door briefly and
closing it properly reduces energy consumption.
Setting the temperature no colder than
necessary contributes to optimal energy use.
The door gaskets of your appliance must be
perfectly intact so that the doors close properly
and energy consumption is not increased
unnecessarily.
11
EN