Troubleshooting - Cleco CellTek AC 00-R0-G1-LD4 Series Assembly Instruction Manual

8

Troubleshooting

Problem
Module does not work
Status LED:
Flashlight yellow for longer than
20 seconds
Status LED:
Continuous red light after switch-
ing on
Status LED:
Off after successful initialization
TAG LED:
No flashing light after initialization
Apex Tool Group
Possible cause
Tool not active
Module not properly installed
Module not activated by software
Wrong software on tool
Tool defective
Module defective
Initialization of the module failed
Module not properly installed
Software out of date
Module defective
Tool defective
Initialization of the module failed
Module defective
Power supply no longer active
Module does not communicate with the
positioning system
P2568MA | REV C l 2025-03
Measure
► Press the start switch on the tool
► Check installation
► Reattach the battery
► Restart tool
► Perform software update with cor-
rect software
► Replace tool
► Replace module
► Reinsert the battery
► Restart the tool
► Check assembly
► Update CellTek-Firmware see soft-
ware.apextoolgroup.com
► Exchange module
► Exchange tool
► Reattach the battery
► Restart tool
► Replace module
► Press the start switch on the tool
► Check whether the tool is within the
reception area
2
EN
9