8 Depress the latch and lift the PIB off the chassis hooks. See Figure 3-27.
9 Remove the PIB from the chassis.
Installing the Power Interposer Board
1 Position the Power Interposer board above the chassis hooks. See
Figure 3-27.
2 Press down on the Power Interposer board until the latch snaps.
3 Connect the SATA PLANAR connector to the Power Interposer board.
4 Connect the PLANAR connector to the Power Interposer board.
5 Connect the control panel connector.
6 Install the system board. See "Installing the System Board" on page 124.
7 Install the SAS backplane. See "Installing the SAS Backplane (2.5" Hard
Drives)" on page 119.
8 Install the optical drive. See "Installing the Optical Drive" on page 89.
Installing System Components
121