Additional Cluster Setup Tasks; Registering The Proliant Cluster For Sco Unixware 7 - Compaq 195294-001 - ProLiant - ML370R Quick Install Manual

Additional Cluster Setup Tasks

After you have installed your cluster, you can configure the nameserver for the
domain name of the cluster or modify the Quick Install default settings outline
in Table 3-1.
NOTE: Information about configuring nameservers using the SCOadmin system
management tool can be found in the SCOhelp online documentation set. You can use the
SCOhelp search tool to locate your information. See "Viewing UnixWare and NonStop
Clusters Documentation" later in this chapter.
You can also perform additional hardware set-up tasks, such as installing
additional network interface controllers (NICs) for the public network,
additional disks and disk volumes, tape drives, and Remote Insight Lights-Out
Edition boards. For installation information, refer to the Compaq
documentation that comes with these devices.
Registering the ProLiant Cluster for SCO
UnixWare 7
After the cluster is verified, go to the Compaq High Availability website to
register the cluster. Compaq sends notification to registered users as software
updates and additional support for SCO UnixWare 7 NonStop Clusters is
made available. To register the cluster, see the Compaq High Availability
website at
http://www.compaq.com/highavailability
Installing Cluster Software 3-15