Power Switch/Led Assembly - Compaq 100eu - All-in-One PC Maintenance & Service Manual

8. If you need to remove the card reader board from the bracket, remove the two Torx screws (1)
that secure the board to the bracket, and then slide the board out of the bracket (2).
Figure 7-25
To reinstall the card reader, reverse the removal procedure.

Power Switch/LED Assembly

Description
Power switch/LED assembly
The power switch/LED assembly is located on the top, right of the computer. The assembly is held in
place with tabs and hooks.
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. Remove the optical drive
5. Disconnect the cable from the black system board connector labeled P22.
6. Remove the cable from the metal clamps on the side of the drive cage. This step may require a
flat blade screwdriver to lift the clamps enough to remove the cable.
Removing the Card Reader Board from the Bracket
(Front Bezel on page
(Removing an Optical Drive on page
(Preparation for Disassembly on page
(Access Panel on page
79).
Spare part number
628801-001
77).
78).
87).
Power Switch/LED Assembly
99