Introduction; Safety Instructions - En-Vision America ScriptAbility Braille RX User Manual

INTRODUCTION

Thank you for your investment in the BrailleRx prescription label printer. This user manual contains the
basic information about the unpacking, installation, setup, and safe use of the printer with our ScriptAbility
Pharmacy Application.
It is recommended that you read carefully and become familiar with each section before installing and
maintaining the printer. Refer to the Table of Contents at the front of this manual to search for the relevant
information needed.

SAFETY INSTRUCTIONS

Please read all these safety instructions before using the BrailleRx prescription label printer. In addition, follow
all warnings and instructions marked on the BrailleRx itself.
• Ensure that there is adequate ventilation around the unit.
• Do not place unit near a radiator or heat source.
• Keep unit out of direct sunlight.
• Make sure that the printer and computer are switched off before connecting the data cable.
• The print head will become very hot during printing; avoid contact with the print head after printing
has finished.
• Do not block or cover slots and openings in the unit's case; do not insert objects through slots.
• Use only the type of power source indicated on the unit's labels.
• Connect all equipment to properly grounded electrical outlets.
• Do not use frayed or damaged power cords. After connecting power cords, ensure that they are not
twisted, knotted, or pinched before using the unit.
• Do not use an extension cord with the unit.
• If using a surge protector, ensure that the total current rating of all connected equipment does not
exceed the maximum rating of the surge protector or wall outlet.
• Unplug the unit before cleaning it; always clean it with a piece of damp cloth only.
• Do not spill liquid into the unit.
• Detach the unit from power source and refer to qualified service personnel under the
following conditions:
o If the power cord or plug is damaged.
o If liquid has entered the unit.
o If the unit has been dropped or tipped over or if the case is damaged.
o If the unit does not operate properly or exhibits a distinct change in performance.
o If the unit becomes extremely hot, or if smoke, unusual smells or abnormal noises are
emitted from the printer.
• Except as specifically explained in the user's manual, do not attempt to service the unit.
• Only adjust those controls that are covered in the user's manual.
• Keep hair, jewelry, and clothing clear of moving parts in the printer and printer.
• When clearing media jams or performing routine cleaning of parts as directed in this manual, use
caution to prevent touching the printer's fuser unit or the printer's motors, as these parts can be hot
and contact may cause injury.
1