INSTALLATION
Examine the oven after unpacking.
1
Check for damage such as a misaligned door, broken door or dent in the cavity.
If any damage is visible, DO NOT INSTALL, and notify your dealer immediately.
Level, flat location.
2
Install the microwave oven on a level, flat surface.
Ventilation.
3
Do not block air vents. If they are blocked during operation, the oven may overheat and eventually
cause a failure.
For proper ventilation, allow 3 inches of space between oven top, sides, rear and adjacent
surfaces. The minimum height of free space necessary above the top surface of the oven is
100mm.
Away from radio and TV sets.
4
Poor television reception and radio interference may result if the oven is located close to a TV,
radio, antenna, feeder, etc. Place the oven as far from them as possible.
Away from heating appliances and water taps.
Keep the oven away from heat, steam or splashing liquids. These things can adversely affect oven
wiring and contacts.
Power supply.
5
This microwave oven requires a power supply of approximately 13 Amperes, 120 Volts, 60Hz and
a grounded outlet.
A short power cord is provided to reduce the risk of the user becoming entangled in or tripping
oven longer cord. Longer cord sets or extension cords are available and may be used if care to
exercised.
If an extension cord is used, the marked electrical rating of the cord should be at least as great as
the electrical rating of the oven. The extension cord must be a grounding-type 3-wire cord. The
longer cord should be arranged so it does not drape over the table top or counter where children
can pull on it or trip over it.
7
Need help?
Do you have a question about the MCD1812W and is the answer not in the manual?