Table of Contents
Advertisement
INSTALLATION
1
Examine the oven after unpacking.
check fork damage such as a misaligned door, broken door or dent in the cavity.
If any damage is visible, DO NOT INSTALL, and notify your dealer immediately.
Level, flat location.
2
Install the microwave oven on a level, flat surface.
Ventilation
3
Do not block air vents. If they are blocked during operation, the oven may overheat and eventually
cause a failure. For proper ventilation, allow 4 inches (10.16mm) of space between oven top, sides,
rear and adjacent surfaces.
Away from radio and TV sets
4
Poor television reception and radio interference may result if the oven is located close to a TV, radio,
antenna, feeder, etc. Place the oven as far from them as possible.
Away from heating appliances and water taps
5
Keep the oven away from heat, steam or splashing liquids. These things can adversely affect oven
wiring and contacts.
Power supply
6
This microwave oven requires a power supply of approximately 20 Amperes, 120 Volts, 60 Hz and a
grounded outlet. A short power cord is provided to reduce the risk of the user becoming entangled in
or tripping over a longer cord. Longer cord sets or extension cords are available and may be used if
care is exercised.
If an extension cord is used, the marked electrical rating of the cord should be at least as great as the
electrical rating of the oven.
The extension cord must be a grounding-type 3-wire cord. The longer cord should be arranged so it
does not drape over the table top or counter where children can pull on it or trip over it.
7
The minimum height of free space necessary above the top surface of the oven is 4 inches
(10.16mm).
When use 3-pronged plug
3-prong Receptacle
3-prong plug
"THE CANADIAN ELECTRICAL CODE DOES NOT ALLOW THE USE OF THE GROUNDING ADAPTOR"
Receptacle
Box cover
4
When use grounding adaptor, make
sure the receptacle box is fully
grounded.
Receptacle Box Cover
Grounding
Lead
Grounding
Receptacle
Adaptor
Advertisement
Table of Contents
