Disabling A Forgotten Password - Dell POWEREDGE E11S Owner's Manual

Disabling a Forgotten Password

The system's software security features include a system password and a setup
password, which are discussed in detail in "Using the System Setup Program
and Boot Manager" on page 23. The password jumper enables these password
features or disables them and clears any password(s) currently in use.
CAUTION:
instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening and Closing the System" on page 45.
3 Remove the jumper plug from the password jumper.
See Figure 6-1 to locate the password jumper (labeled "PWRD_EN") on
the system board.
4 Close the system. See "Closing the System" on page 46.
The existing passwords are not disabled (erased) until the system boots
with the password jumper plug removed. However, before you assign a new
system and/or setup password, you must install the jumper plug.
NOTE:
plug still removed, the system disables the new password(s) the next time it
boots.
5 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
6 Open the system. See "Opening and Closing the System" on page 45.
7 Install the jumper plug on the password jumper.
8 Close the system. See "Closing the System" on page 46.
9 Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "Assigning
a System Password" on page 38.
122
Jumpers and Connectors
See "Protecting Against Electrostatic Discharge" in the safety
If you assign a new system and/or setup password with the jumper