Magnavox MRV700VR - Dvd Recorder / Vcr Owner's Manual page 16

E9490UD_EN.qx3 04.9.21
16 Hookups (cont'd)
1
Connect your Antenna or Cable TV signal to the ANTENNA IN jack
on the rear of the Recorder.
2
Connect the Recorder's COAXIAL DIGITAL AUDIO OUT jack to
your Stereo's COAXIAL DIGITAL AUDIO IN jack.
digital audio cable (not supplied).
3
Connect the Recorder's yellow VIDEO OUT jack to your TV's
VIDEO IN jack.
4
Connect the supplied RF coaxial cable to the ANTENNA OUT jack
on the rear of the Recorder. Connect the other end of the same RF
coaxial cable to the Antenna In jack on your TV.
jack may be labelled RF In,Antenna In, or 75 ohm. Check your TV manual for
details.
5
Connect the power cords of the Recorder, Stereo, and TV to a
power outlet.
6
Turn on the Stereo power and set your Stereo to the correct Digital
Audio In channel or sound source.
7
Press STANDBY-ON
If "IS TV ON? C03" appears on the display panel, you need to turn on your TV
and set it to the correct Video In channel. (See next step.) You cannot see the
Initial Setup screens until you turn on the TV and have it on the correct Video
In channel.
8
Turn on the TV power. Set the TV to the correct Video In channel.
This is not channel 3 or 4 if you are using the connection shown. See your TV
manual.Your TV remote may have a button or switch that selects the Video In
channel. Or, go to your lowest TV channel and change channels down until you
see the DVD background picture or Initial Setup screen on the TV. The Initial
Setup screen will appear the first time you turn on the Recorder. Go to page 18 to
continue.
10:54 AM Page 16
Connecting to a TV and a Digital Stereo
(Stereo has Dolby Digital
Use the supplied video cable that has yellow markings.
Refer to the Stereo owner's manual.
y y to turn on the Recorder.
TM or MPEG2)
Use a coaxial
Your TV's Antenna In
Helpful Hints
• Digital audio is only available for
the Discs you play.You still must
make a stereo audio connection
(red/white cables) or the RF
coaxial connection to have sound
at the VCR.
• Set Digital output accordingly. See
page 64. If the Digital output
setting does not match your
Stereo's capabilities, the Stereo
may produce a strong, distorted
sound or no sound at all.
• Your Stereo must support Dolby
Digital TM or MPEG2. Check the
Stereo's manual.
• To use Component Video or
S-Video instead, see pages 12
and 13.You only need one video
connection. Choose the correct
Video In channel at the TV.