Connecting To A Tv And A Stereo - Magnavox MRV700VR - Dvd Recorder / Vcr Owner's Manual

E9490UD_EN.qx3 04.9.21
1
Connect your Antenna or Cable TV signal to the ANTENNA IN jack
on the rear of the Recorder.
2
Connect the Recorder's yellow VIDEO OUT jack to your TV's
VIDEO IN jack.
3
Connect the supplied audio cable to the Recorder's white/red
AUDIO OUT L/R (left/right) jacks and to the left/right AUDIO IN
jacks on the Stereo.
cable colors to the jack colors.
4
Connect the supplied RF coaxial cable to the ANTENNA OUT jack
on the rear of the Recorder. Connect the other end of the same RF
coaxial cable to the Antenna In jack on your TV.
jack may be labelled RF In,Antenna In, or 75 ohm. Check your TV manual for
details.
5
Connect the power cords of the Recorder, Stereo, and TV to a
power outlet.
6
Turn on the Stereo and set it to the correct Audio In channel or
sound source.
7
Press STANDBY-ON
If "IS TV ON? C03" appears on the display panel, you need to turn on your TV
and set it to the correct Video In channel. (See next step.) You cannot see the
Initial Setup screens until you turn on the TV and have it on the correct Video
In channel.
8
Turn on the TV power. Set the TV to the correct Video In channel.
Such channels may be called AUX or AUXILIARY IN,AUDIO/VIDEO or
A/V IN, EXT1 or EXT2 or External In, etc. This is not channel 3 or 4 if you
are using the connection shown. See your TV manual. Your TV remote may
have a button or switch that selects the Video In channel. Or, go to your
lowest TV channel and change channels down until you see the DVD
background picture or Initial Setup screen.
The Initial Setup screen will appear the first time you turn on the Recorder. Go to
page 18 to continue.
10:54 AM Page 15

Connecting to a TV and a Stereo

Use the supplied video cable that has yellow markings.
The audio cable has red and white markings. Match the
Refer to the Stereo owner's manual.
y y to turn on the Recorder.
Hookups (cont'd) 15
Your TV's Antenna In
Helpful Hints
• Set Analog output accordingly.
See page 65.
• To use Component Video or
S-Video instead, see pages 12
and 13.You only need one video
connection. Choose the correct
Video In channel at the TV.