ViewSonic ViewBoard IN01 Series User Manual page 125

LAN Hardware Specification
ViewSonic LFD communication port on the rear side:
1. Connector type: 8P8C RJ45
2. Pin Assignment:
RS-232 Communication Setting
• Baud Rate Select:
• Data bits:
• Parity:
• Stop Bits:
LAN Communication Setting
Type:
Protocol:
Port:
WOL Port:
Cross subnet:
Logon Credentials:
Command Message Reference
PC sends to LFD command packet followed by "CR". Every time PC sends control
command to Display, the Display shall respond as follows:
1. If the message is received correctly it will send "+" (02Bh) followed by "CR"
(00Dh)
2. If the message is received incorrectly it will send "-" (02Dh) followed by "CR"
(00Dh)
Pin # Signal
1 TX+
2 TX-
3 RX+
4 BI_D3+ For 1G case
5 BI_D3- For 1G case
6 RX-
7 BI_D4+ For 1G case
8 BI_D4- For 1G case
frame GND
115200 bps (fixed)
8 bits (fixed)
None (fixed)
1 (fixed)
Ethernet
TCP/IP
5000 (fixed)
9 (fixed) for UDP
No
No
125
Output from Display
Output from Display
Input to Display
Input to Display
*3.2.0
Remark