Water Connection - Whirlpool ADG 175 Instruction Manual

WARNING!

Water Connection

WARNING!
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at a height of be tween 50 cm (minimum) and 100 cm (maximum)
from the bottom of the dish. T he water drain hose should be fixed by a hose clip.
Start of Dishwasher
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
Improper connection of the equipment earthing conductor can result in the risk of an electric shock.
for personal safety:
Check with a qualified electrician or service representative if you are in doubt whether the
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
appliance is properly earthed.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet,
CONNECTION FROM THE POWER CORD.
please have a qualified electrician to install a proper outlet.
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time , let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water in let to be blocked and damage the a ppliance.
Th e water supply to the applianc e can also be connected to the house hold hot water
line (such as, central system, heating system),as long as it does not exceed a
temperature of 60 C. In this case, the wash cycle time will be shortene d by about 15
minute s and the wash efficiency slightly reduced .
Th e co nnection must be made to the hot water line following the same procedures as
described in the sec tion for the c onnection to the cold water line.
In or der to avoid that there is more water staying in the inlet hose, please close
the hydrant after using.(Not applicable to appliances without aqua-stop.)
22
EARTHING