Installation And Assembly; First Start Up - Electrolux Professional 6GN 1/1 Service Manual

2

INSTALLATION AND ASSEMBLY

Refer to "Installation manual" available in Pride/Agelux/Toolbox for a complete guide and reference for a correct installation
of the oven in terms of power, water, gas supply and drain connection.

2.1 FIRST START UP

Once that all the supplies connections have been carried out it's time to startup the appliance.
Remove the entire protective film from all the panelings and door; the protective film can be easily removed when the
appliance has not been heated up. If the appliance is run for a long period without removing the protective film the film
could melt and then be difficult to remove / damage the panelings finishing.
Before you turn on the appliance make sure that:
CHECK THE INTERIOR
Open the door, make sure that all parts are placed in correct location.
Make sure that there are no irrelevant parts inside the machine (for example: hanging cloth, screws, nuts, tools, packaging
materials, etc.).
WATER SUPPLIES:
Water is present in the pipelines and available pressure is rated suitable to supply correctly the appliance. Make sure that
the inlet mains pipes have been flushed so that any debris will not jam the inlet water filters/system of the oven.
ELECTRIC SUPPLIED APPLIANCES:
the mains voltage and frequency match those indicated on the appliance data plate.
Fasten all terminals in the control box, check if all of them are tightened, visual test for all the electrical equipment if they
are in good condition, (for example: switches, cables, motor shell, etc.), and test all the functions of power switch.
15