Advertisement

Sonoff LBS D1 Manual

Operating Instruction

  1. Power off
    warning To avoid electric shocks, please consult the dealer or a qualified professional for help when installing and repairing! Please do not touch the switch during use.
  2. Wiring instruction
    Operating Instruction - Step 1
    information The device can only connect incandescent light bulb and dimmable LED light.
    information Make sure the neutral wire and live wire connection is correct.
  3. Download APP

    Android™ & iOS

    www.apple.com

    play.google.com
  4. Power on
    Operating Instruction - Step 2
    After powering on, the device will enter the quick pairing mode (Touch) during the first use. The connected light enters the "breathing mode".
    information It will exit the quick pairing mode (Touch) if the device is not paired within 3mins. If you need to enter this mode again, please power off and restart the device until the connected light enters the "breathing mode".

5.Add the device
Operating Instruction - Step 3
Tap "+" and select " Quick Pairing ", then operate following the prompt on the app.

Pairing method for the device and SONOFF RM433 remote controller:

Short press any button on the RM433 remote controller within 5s after powering on until you hear "Bi", which indicates all buttons are paired successfully.

information The RM433 remote controller is not included, please purchase it separately.

RM433 Introduction

Buttons Functions
On
Off
Short press for the low brightness, long press to turn down the brightness
Short press for the medium brightness, long press to turn down the brightness
Short press for the higher brightness, long press to turn up the brightness
Short press for the high brightness, long press to turn up the brightness

Long press for 5s until you hear "Beep Beep" and release, then the remote controller is cleared successfully.

After clearing code is completed, if you need to use, short press any button within 5s after powering on again and you will hear"Beep", which indicates the remote controller is paired successfully.

Long press for 5s until the connected light enters the breathing mode, which indicates the device enters quick pairing mode (Touch), then you can add the light on eWeLink APP. In quick pairing mode, you can short press any button on the remote controller to exit this mode.

Specifications

Model D1
Input 100-240VAC50/60Hz
Output 100-240VAC50/60Hz
Light Load Incandescent: 200W LED:150W
Operating systems Android & iOS
Wi-Fi IEEE 802.11 b/g/n 2.4GHz
RF 433.92MHz
Working temperature -10℃~40℃
Material PC V0
Dimension 62x47x32.5mm

Features

D1 is a Wi-Fi smart dimmer switch that is used to adjust the light brightness and set various atmosphere for your room. You can remotely turn on/off light of your home anywhere, schedule it on/off, or share it with your family to control together.

  • Remote Control
  • Single/Countdown Timing
  • Voice Control
  • Share Control
  • Smart Scene
  • 433MHz Remote Control
  • Stepless dimming
  • Scene Mode
  • LAN Control
  • Group control

Factory Reset

Turn on and off 3 times on repeatedly or delete the connected light on eWeLink APP until it enters "breathing mode", then the device is reset successfully and enters quick pairing mode (Touch).
Factory Reset

information Please reset the device to factory defaults if you want to use other Wi-Fi networks, then reconnect the network.

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Sonoff LBS D1 Manual

Advertisement

Need help?

Need help?

Do you have a question about the LBS D1 and is the answer not in the manual?

Questions and answers

Table of Contents