SERVICE MANUAL Contents Chapter 1 General Information ........................2 1-1. General Guidelines ..........................2 1-2. Insurance test ............................2 Chapter 2 Product Feature ..........................3 2-1. Specifications ............................3 2-2. External views ............................4 2-4. Main features ............................. 6 Chapter3 Disassembly and Installation ......................7 3-1.
SERVICE MANUAL Chapter 1 General Information 1-1. General Guidelines When servicing, observe the original lead dress. If a short circuit is found, replace all parts which have been overheated or damaged by the short circuit. After servicing, see to it that all the protective devices such as insulation barriers, insulation papers shields are properly installed.
SERVICE MANUAL Chapter 2 Product Feature 2-1. Specifications Model HRF565YHS HRF565YHC Door type Sheet metal Sheet metal Exterior Titanium (ACM) Black (ACM) Power consumption kWh/year Total effective volume Effective volume of refrigerator compartment Effective volume of freezer compartment Freezing capacity...
SERVICE MANUAL 2-2 Space requirement Appliance width in mm Appliance depth in mm Model HRF565YHS 1105 1362 HRF565YHC 1105 1362 2-3.Parameter Spare parts list The main parameters Picture Power:40-131 EER:1.70-1.80 Refrigerating capacity :61-223W Compressor working current:0.30-1.24 the main winding resistance at 25℃ 11.5 Volt: 12V Frz.
Adjusting shelf height:The shelf can be relocated to accommodate food size or height. Humidor zone: the humidor box at the refrigerating compartment can retain freshness of food effectively. 2-5. Explanation of The Models steel colour(C:black S:satina) External water intake T-Door Refrigerator’s Net Capacity Haier /No frost...
SERVICE MANUAL Chapter3 Disassembly and Installation Note: Unplug the power cord from the outlet when demount the refrigerator. 3-1. Disassemble refrigerator compartment partition plate Remove the drawer Take out the shelf. With the front end slightly ○ ○ raised, the upper and lower shelves can be removed.
SERVICE MANUAL 3-2. Disassemble the refrigerator air duct After step 3-1, remove the screw covers ○ ○ ○ (indicated by the red circles). 2. The decorative cover is removed forcibly. 3. After step 3-2, the decorative cover was removed. 4. Gently pull the air duct out with both hands.
Page 10
SERVICE MANUAL 3-3. Disassemble the air damper ○ Remove the PE tape on the back of the air duct. Tear the crepe paper adhesive tape around it. 。 Remove thecrepe paper adhesive tape ○ and take the damper out. ③ 3-4.
Page 11
SERVICE MANUAL 3-5.Disassemble the freezer air duct After step 3-4, As indicated in the figure, support the lower end of the freezer compartment air duct with your hand, ○ pull it up with force and then slowly pull it forward. Attention should be paid not to exert too much force, to avoid breaking the cables.
Page 12
SERVICE MANUAL 3-7. Defrost heater wire disassembly method Remove the defrost heater wire terminal and gently separate the two clips fixing the defrost heater wire. Then, pull the defrost heater wire out through the fixing clip on the right, as indicated by the red circle in the figure.
Page 16
SERVICE MANUAL Connectors ‘ location on PCB CN 2 CN 1 CN 5 CN 3 CN10 CN 9 Press the button, the product can enter T mode, for it is danger, so it is safety to enter from display panel, it is main for the factory test...
Page 17
SERVICE MANUAL Connector Wire Parts Position of Normal name connecting connecting parts working parameter (color) 1 LED 1 YELLOW 3 12V 3 PINK 5 R-SNR 5 GRAY 6 GND 6 BLUE 7 GREEN 7 F-SNR 8 BROWN 8 D-SNR ORANGE 9 GND 10 PURPLE 10 FAN-F...
Page 18
SERVICE MANUAL 1 GND 1 WHITE 3 ORANGE 3 R-SW 5 GREEN 5 RT-SNR 6 GRAY 7 WHITE 6 Humidity sensor 8 BLACK 7 GND 8 5V 1 WHITE 2 BLUE 3 YELLOW 4 RED 1~4 DAMPER 5 WHITE 5~8 DISPLAY 6 BLACK 9~10 PWM 7 RED...
SERVICE MANUAL 1 BLUE 3 BLUE 1,9:DEFROST HEAT 3,11:Beam heating wire 7 BLACK 7:Compressor power 10 / 11 BROWN 5-3 PCB pins break method Display board without break Chapter 6 Main Function Operating principle 6-1 Defrost system 6-1-1 defrost control : According to the times of opening and closing the door and the time of the compressor cumulative working, the refrigerator has different frost timing .
Page 20
SERVICE MANUAL reaches 7℃,the defrost stops, in defrosting the compressor and freezer fan are off, the refrigeration damper closes. If the defrost time reaches 90 minutes, but the temperature of the defrost sensor does not reach 7℃, then the defrost heater is off, Ed displays. 6-1-2.
SERVICE MANUAL 7-1 Control and display panel Function introduction (see User Manual) (1) Initial powering on When the power of the refrigerator is turned on for the first time, the display panel will be lit, and the temperature fridge will be automatically set at 5°C and the temperature freezer at -18°C. The temperature indicators in the refrigerator and freezer compartments will show the actual temperature.
Page 23
SERVICE MANUAL stops blinking, the temperature indicated in area A –“Fridge” shows the actual temperature of the refrigerator compartment. When the temperature reaches 8°C, continue to press key A “Fridge” and the temperature will cycle to the lowest temperature of 1°C. The refrigerator compartment temperature cycles in the following way: “04→03→02→01→OF→08→07→06→05→04”.
Page 24
SERVICE MANUAL 2) Under Power Cool mode, press key D “Power Cool” and the Power Cool icon d will go out; the refrigerator exits Power Cool mode. Note: Under Power Cool mode, the fridge storage temperature cannot be adjusted. If you press the “Fridge” to adjust the temperature, the Power Cool icon will blink, indicating that you cannot carry out the operation.
SERVICE MANUAL 7-2 Function adjustment 7-2-1 First, The panel is unlocked. Touch the button F for 3 seconds. 7-2-2 Adjust the fridge temperature Press the button A to adjust. 7-2-3...
SERVICE MANUAL Chapter 8 Quick check and Self-test model 8-1 Checking method of fault code Entry mode: Enter method: In the locked state, press and hold the “ Fridge” key and press the “SMART mode and holiday function selector” key 5 times; the buzzer will beep once and it will enter the error code mode. The error code will be indicated in the corresponding temperature indicating area (will be indicated if there is no fault code).
SERVICE MANUAL Fault code Error code Defect Explanation Remark Freezer sensor fault Freezer defrosting sensor fault Refrigerator sensor fault Humidity sensor fault For 4D Communication fault between PCB and display panel Check the heater , fuse and Freezer defrosting fault communication 8-2 Test mode 1) In the locked state, press and hold the “Fridge”...
SERVICE MANUAL mode Working will When the display With T2 indicated on the panel, press the “Lock” key rule indicated in the panel indicates fridge and freezer press and T3 will be shown on the the ”Lock” key temperature panel. The main control panel indicator areas and will has no T3 mode control and...
SERVICE MANUAL 8-4 Sensor layout plan Designation Symbol Location Left middle freezer Freezer sensor F SNR compartment air duct cover Lower left of refrigerator Refrigerator sensor R SNR compartment air duct Freezer/defrost sensor F/D SNR On freezer evaporator Humidity sensor Humidity SNR Below the right hinge box...
Page 30
SERVICE MANUAL Value of the sensors The resistance(±5%KΩ) resistance(±5%KΩ) T(℃) T(℃) R type F type R type F type 33.070 33.84 6.038 6.162 31.160 31.88 5.743 5.861 29.370 30.04 5.464 6.576 27.690 28.32 5.201 5.306 26.120 26.70 4.950 5.051 24.640 25.19 4.714 4.810...
SERVICE MANUAL Chapter 9 Trouble shooting 9-1.Typical faults and solutions 1) NO Cooling NO cooling Stop the refrigerator and Conduct overhaul according to the turn the power on 10min section “Refrigerator will not start” later; check whether the compressor works Whether the compressor Refrigerant leakage;...
Page 32
SERVICE MANUAL 2) Refrigerator will not stop Refrigerator will not stop Conduct overhaul according to the Whether refrigeration “Refrigeration section is functioning functioning” Whether refrigeration Conduct overhaul according to the section “Refrigeration temperature not temperature is not low enough low enough” Adjust it and guide the user to 1.
Page 33
SERVICE MANUAL 3) Refrigeration temperature not low enough Refrigeration temperature not low enough Replace the door Whether the door gasket is deformed and leaks cold air Adjust it and guide the user to operate Whether temperature is not properly properly set Repair it Whether there refrigerant leakage in the system...
Page 34
SERVICE MANUAL 4) Refrigerator will not start Refrigerator will not start Check socket Check whether the power socket replace the power cord and plug contact well Whether the terminals contact well Check whether the main control Replace the fuse panel fuse is blown Check intactness Whether 220V is indicated on...
Page 35
SERVICE MANUAL 5) Defrost not functioning Defrost not functioning Check the main control panel output and defrost heater wire Whether there is voltage on the defrost heater wire Replace the fuse Whether the fuse is already blown Replace the heater The heater wire is broken (open wire circuit)
SERVICE MANUAL 9-2. Answers to frequently asked questions ① The refrigerator does not work ● Check whether the power is connected (the plug, socket, fuse, etc.). ● Whether the supply voltage is too low. ② The refrigerator produces noise ● Since the refrigerant flows in the pipeline, it will produce noise and it is normal. ●...
Page 37
SERVICE MANUAL ● In the case of initial use, it will run for a long time and it is normal. ● A large amount of food is put in the refrigerator one time for cooling. ● The weather is hot or door frequently opened. ●...
Page 38
SERVICE MANUAL Sincere forever Haier Group Haier Industrial Park, No.1, Haier Road 266101, Qingdao, China http://www.haier.com Please login the Haier technical support website for more product information. http://community.haierdealer.com/km...
Need help?
Do you have a question about the HRF565YHS and is the answer not in the manual?
Questions and answers