Advertisement

Quick Links

EN User Manual | Dishwasher
EEG68600W

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EEG68600W and is the answer not in the manual?

Questions and answers

Summary of Contents for Electrolux EEG68600W

  • Page 1 EN User Manual | Dishwasher EEG68600W...
  • Page 2: Table Of Contents

    Welcome to Electrolux! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.electrolux.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. INSTALLATION....................6 4. PRODUCT DESCRIPTION................7 5.
  • Page 3: General Safety

    • Children between 3 and 8 years of age and persons with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. • Children of less than 3 years of age should be kept away from the appliance unless continuously supervised.
  • Page 4: Safety Instructions

    • Do not use high pressure water sprays and/or steam to clean the appliance. • If the appliance has ventilation openings in the base, they must not be covered e.g. by a carpet. • The appliance is to be connected to the water mains using the new supplied hose-sets.
  • Page 5: Internal Lighting

    • Please note that self-repair or non- professional repair can have safety consequences and might void the guarantee. • The following spare parts are available for at least 7 years after the model has been discontinued: motor, circulation and drain pump, heaters and heating elements, including heat pumps, piping and related equipment including hoses, valves, filters...
  • Page 6: Installation

    Authorized Service Centre to replace it with appliance. the new one. 3.1 Building in www.youtube.com/electrolux www.youtube.com/aeg How to install your AEG/Electrolux 60 cm Sliding Door Dishwasher min. 560 1240 3.2 Safety caps If the furniture panel is not installed, open the appliance door carefully to avoid the risk of injury.
  • Page 7: Product Description

    4. PRODUCT DESCRIPTION Ceiling spray arm Scan the QR code with the camera on your mobile device to be redirected to the app in Upper spray arm the app store. Follow the instructions on your Lower spray arm mobile device to download the app. Filters Scan the QR code with the scanner in the Rating plate...
  • Page 8: Control Panel

    5. CONTROL PANEL On/Off button / Reset button A. ECOMETER B. Indicators Delay start button / Remote start button C. Time indicator Display 5.2 ECOMETER MY TIME program selection bar Option buttons (EXTRAS) AUTO Sense program button 5.1 Display The ECOMETER indicates how the programme selection impacts energy and water consumption.
  • Page 9: Programme Selection

    6. PROGRAMME SELECTION 6.1 MY TIME The appliance senses the degree of soil and the amount of dishes in the baskets. It adjusts MY TIME selection bar allows to select a the temperature and quantity of water as well suitable dishwashing cycle based on as the wash duration.
  • Page 10 6.5 Programmes overview Programme Dishwasher Degree of Programme phases EXTRAS load soil Quick Crockery, cutlery Fresh • Dishwashing 50 °C • ExtraPower • Intermediate rinse • GlassCare • Final rinse 45 °C • ExtraHygiene • AirDry Not applicable • Prewash Pre-rinse Crockery, cutlery Fresh, lightly •...
  • Page 11: Consumption Values

    Consumption values Water (l) Energy (kWh) Duration (min) Programme 1)2) Quick 11.0 0.620 Pre-rinse 0.010 11.8 0.970 1h 30min 11.9 1.110 2h 40min 11.9 1.210 10.9 0.542 AUTO Sense 12.1 1.220 Machine Care 10.6 0.710 The pressure and the temperature of the water, the variations of the mains supply, the options, the quantity of dishes and the degree of soil can change the values.
  • Page 12: Setting Mode

    You can change the basic settings in setting The lights related to the Previous, OK and mode. Next are on. When the appliance is in setting mode, the How to change a setting bars of the ECOMETER represent available settings. For each setting, a dedicated bar of Make sure the appliance is in setting mode.
  • Page 13: The Water Softener

    1. Press and hold the on/off button until the negative effect on the washing results and on dishwasher is activated. the appliance. 2. Press and hold Previous and Next for 5 The higher the content of these minerals, the seconds. harder your water is.
  • Page 14: The Rinse Aid Level

    7.5 The rinse aid level Water softener level Amount of water (l) The rinse aid helps to dry the dishes without streaks and stains. It is automatically released during the hot rinse phase. It is possible to set the released quantity of rinse aid.
  • Page 15: Key Tones

    When AirDry opens the door, the display TimeBeam displays the following information shows the remaining time of the running on the floor below the appliance door: programme. • The programme duration when the programme begins. CAUTION! • 0:00 and CLEAN when the programme is completed.
  • Page 16: Before First Use

    4. To activate the wireless connection, press • The display shows Off for a few seconds. and hold simultaneously • The appliance returns to the for 2 seconds. programme selection. • The indicator flashes. • The display shows On for a few 8.3 How to activate the wireless seconds and then AP.
  • Page 17: The Salt Container

    9.1 The salt container 9.2 How to fill the rinse aid dispenser CAUTION! Use only regeneration salt for dishwashers. Do not use kitchen salt. The salt is used to recharge the resin in the water softener and to assure good washing results in daily use.
  • Page 18: Daily Use

    10. DAILY USE 1. Open the water tap. 2. Press and hold until the appliance is The upper ends of the two vertical ribs activated. inside the compartment (B) indicate the 3. Fill the salt container if it is empty. maximum level for filling the dispenser 4.
  • Page 19: How To Delay The Start Of A Programme

    10.6 How to start the AUTO Sense • The display shows the programme program duration. 2. Activate applicable EXTRAS if desired. 3. Close the appliance door to start the 1. Press programme. • The light related to the button is on. •...
  • Page 20: Opening The Door While The Appliance Operates

    Make sure that there is detergent in the If the door is opened for more than 30 detergent dispenser before you start a seconds during the drying phase, the new programme. running programme ends. It does not happen if the door is opened by the 10.10 Opening the door while the AirDry function.
  • Page 21: Using Salt, Rinse Aid And Detergent

    11.3 What to do if you want to stop • Select a programme according to the type using multi-tablets of load and the degree of soil. ECO offers the most efficient use of water and energy Before you start using separately detergent, consumption.
  • Page 22: Care And Cleaning

    • Put cutlery and small items in the cutlery 2. First remove items from the lower basket, drawer. then from the upper basket. • Move the upper basket upwards to accommodate large items in the lower basket. After the programme is completed, water •...
  • Page 23: External Cleaning

    CAUTION! If unable to remove the foreign objects, contact an Authorised Service Centre. 1. Disassemble the filters system as instructed in this chapter. 2. Remove any foreign objects manually. 3. Reassemble the filters as instructed in 2. Remove the filter (C) out of filter (B). this chapter.
  • Page 24: Cleaning The Lower Spray Arm

    2. Wash the spray arm under running water. 7. Reassemble the filters (B) and (C). Use a thin pointed tool, e.g. a toothpick, 8. Put back the filter (B) in the flat filter (A). to remove particles of soil from the holes. Turn it clockwise until it locks.
  • Page 25 2. To detach the spray arm from the basket, holes. Clogged holes can cause press the spray arm upwards and unsatisfactory washing results. simultaneously turn it clockwise. The ceiling spray arm is placed on the ceiling of the appliance. The spray arm (C) is installed in the delivery tube (A) with the mounting element (B).
  • Page 26: Troubleshooting

    5. To install the spray arm (C) back, insert the mounting element (B) in the spray arm and fix it in the delivery tube (A) by turning it clockwise. Make sure that the mounting element locks into place. 6. Install the cutlery drawer on the sliding rails and block the stoppers.
  • Page 27 Problem and alarm code Possible cause and solution The anti-flood device is on. • Close the water tap. The display shows i30. • Make sure that the appliance is correctly installed. • Make sure the baskets are loaded as instructed in the user manual. Malfunction of the water level detec‐...
  • Page 28 Problem and alarm code Possible cause and solution Rattling or knocking sounds from • The tableware is not properly arranged in the baskets. Refer to basket the inside of the appliance. loading leaflet. • Make sure that the spray arms can rotate freely. The appliance trips the circuit-beak‐...
  • Page 29 13.2 The dishwashing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • Refer to "Daily use", "Hints and tips" and the basket loading leaf‐ let. • Use more intensive washing programme. • Activate the ExtraPower option to improve the washing results of a selected programme.
  • Page 30 Problem Possible cause and solution Limescale deposits on the tableware, • The level of salt is low, check the refill indicator. on the tub and on the inside of the • The cap of the salt container is loose. door. •...
  • Page 31: Technical Information

    Problem Possible cause and solution The app cannot connect to the dish‐ • There is a trouble with the wireless network signal. Check your wire‐ washer. less network and router. Restart the router. • Check if your mobile device is connected to the network. •...
  • Page 32: Environmental Concerns

    15. ENVIRONMENTAL CONCERNS appliances marked with the symbol with Recycle materials with the symbol . Put the the household waste. Return the product to packaging in relevant containers to recycle it. your local recycling facility or contact your Help protect the environment and human municipal office.
  • Page 36 The software in this product contains components that are based on free and open source software. Electrolux gratefully acknowledges the contributions of the open software and robotics communities to the development project. To access the source code of these free and open source software components whose license conditions require publishing, and to see their full copyright information and applicable license terms, please visit: http://electrolux.opensoftwarerepository.com (folder NIUS)

Table of Contents