Sunricher SRP-2305N-24-240LCV Manual

240W 24V DALI DT8 NFC LED Driver(Constant Voltage)
2
Important: Read All Instructions Prior to Installation
Function introduction
DALI signal input
AC Push input
DA PUSH DIM
L DA
DA
DALI NFC Driver
N DA
NC
ACN
ACL
AC/DC power
input
Product Data
LED Channel
DC Voltage
Max. Current
Output
Voltage Accuracy
Rated Power
Voltage Range
Absolute Voltage Range
Frequency Range
Power Factor (Typ.)
Total Harmonic
Distortion (Typ.)
Input
Efficiency (Typ.)
AC Current (Typ.)
Inrush Current (Typ.)
Leakage Current
Standby Power
Consumption
Anti Surge
Dimming Interface
Dimming Range
Control
Dimming Method
Dimming Curve
IS ------
THOMAS SAMUEL THOMAS SAMUEL
R-xxxxxxxx
Wire Gauge：
Input：0.75-2.5mm²
Output：0.5-2.5mm²
2
24VDC
Max. 10A(CH1+CH2)
±3%( ±1%@Certain full load) @ full load
Max. 240W
220-240VAC/220-240VDC
196-264VAC/196-264VDC
0/50/60Hz
> 0.98 @ 230VAC Full load*
THD ≤ 12% (@ full load / 230VAC)*
＞90% @ 230VAC full load*
1.2A@230VAC
Max. 29.2A at 230VAC; 1ms duration
< 5mA /230VAC
＜0.5W
L-N:2KV
DALI Device Type 8 (DALI consumption < 2mA)/ AC Push
0.1%-100%@ Max current
Amplitude/CCR dimming
Linear/ Logarithmic optional
Short Circuit
Over Current
Protection
Over Temperature
Working Temp.
Max. Case Temp.
Environment
Working Humidity
LED Output
Storage Temp.
& Humidity
Safety Standards
WW-
CW-
Withstand Voltage
Safety &
Isolation Resistance
EMC
EMC Emission
EMC Immunity
Others
Dimension
Warranty
*: PF/THD/Eff shall be different per different testing setup and equipment.
• In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2, IEC 62386-209:2011
• Built-in DALI-2 interface, DALI DT8 device
• Dimmable LED driver. Max. output power 240W
• 2 channels DC 24V constant voltage output
• DALI Address/Group/Scene setting via NFC program tool.
• Class Ⅱ power supply, full isolated plastic case
• High power factor and efficiency
• Capable of ON/OFF, brightness, color temperature control
• Amplitude/CCR dimming, smooth and deep dimming
• Compatible with universal DALI masters that support DT8 commands
• DALI-251/252/253 Enabled, DALI data inside. Error report function
• IP20 rating, suitable for indoor LED lighting applications
• 5 years warranty
Safety & Warnings
• DO NOT install with power applied to the device.
• DO NOT expose the device to moisture.
Operation
With DALI master
1. DALI Address
1 DALI address for 2 channels output are assigned by DALI Master controller automatically, please refer to user
manuals of compatible DALI Masters for specific operations.
Yes, remove the fault conditions and re-power the device.
Yes, remove the fault conditions and re-power the device.
Yes, remove the fault conditions and re-power the device.
-25℃ ~ +45℃
10% ~ 95% RH non-condensing
-40℃ ~ +80℃, 10% ~ 95% RH
EN61347-1, EN61347-2-13, GB/T 19510.1-2023, GB/T 19510.213-2023
I/P-O/P: 3.75KVAC
I/P-O/P: 100M Ohms / 500VDC / 25℃ / 70% RH
EN55015, EN61000-3-2, EN61000-3-3, GB 17625.1-2022, GB/T 17743-2021
EN61547, EN61000-4-2,3,4,5,6,8,11
191350H, MIL-HDBK-217F @ 230VAC full load
MTBF
and 25℃ ambient temperature
370.5x49.6x30.5mm (L*W*H)
Tc=85℃
5 Years