Battery - BMW R 1200 S Rider's Manual

When jump-starting the engine,
8
do not disconnect the battery
from the on-board electrical
112
system.
z
Remove the protective cap
from the battery's positive ter-
minal 1.
Run the engine of the donor
vehicle during jump-starting.
Begin by connecting one end
of the red jump lead to the
positive terminal of the dis-
charged battery and the other
end to the positive terminal of
the donor battery.
Then connect one end of the
black jump lead to the negative
terminal of the donor battery,
and the other end to negative
terminal 2 of the discharged

battery.

Start the engine of the vehicle
with the discharged battery
in the usual way; if the en-
gine does not start, wait a few
minutes before repeating the
attempt in order to protect the
starter motor and the donor

battery.

Allow both engines to idle for a
few minutes before disconnect-
ing the jump leads.
Disconnect the jump lead from
the negative terminals 2 first,
then disconnect the second
jump lead from the positive
terminals 1.
Seat the protective cap on bat-
tery positive terminal 1.
Do not use proprietary
start-assist sprays or oth-
er products to start the engine.
Install the front seat (
Battery
Maintenance instructions
Correct upkeep, recharging and
storage will prolong the life of
the battery and are essential if
warranty claims are to be con-
sidered.
Compliance with the points be-
low is important in order to max-
imise battery life:
Keep the surface of the battery
clean and dry
Do not open the battery
Do not top up with water
Be sure to read and comply
with the instructions for char-
ging the battery on the follow-
ing pages
Do not turn the battery upside
down
65)