General Failure; Keyboard Controller - Dell POWERVAULT NX200 Hardware Owner's Manual

Table 1-2. System Messages
Message

General failure

Invalid
configuration
information -
please run SETUP
program.
Keyboard
controller
failure
Keyboard data
line failure
Keyboard stuck
key failure
Keyboard fuse has
failed
Local keyboard
may not work
because all user
accessible USB
ports are
disabled. If
operating
locally, power
cycle the system
and enter system
setup program to
change settings.
Manufacturing
mode detected
40
About Your System
(continued)
Causes
The operating system is
unable to carry out the
command.
An invalid system
configuration caused a
system halt.
Faulty keyboard controller;
faulty system board
Keyboard cable connector is
improperly connected or the
keyboard is defective.
Overcurrent detected at the
keyboard connector.
The USB ports are disabled
in the system BIOS.
System is in
manufacturing mode.
Corrective Actions
This message is usually
followed by specific
information. Note the
information, and take the
appropriate action to resolve
the problem.
Run the System Setup
program and review the
current settings. See "Using
the System Setup Program
and UEFI Boot Manager" on
page 51.
See "Getting Help" on
page 157.
Reseat the keyboard cable.
If the problem persists,
see "Troubleshooting a USB
Device" on page 130.
See "Getting Help" on
page 157.
Power down and restart the
system from the power
button, and then enter the
System Setup program to
enable the USB port(s).
See "Entering the System
Setup Program" on page 52.
Reboot to take the system
out of manufacturing mode.