Lcd Status Messages - Dell POWERVAULT NX200 Hardware Owner's Manual

NOTE:
The following LCD status messages are displayed in the Simple format.
Table 1-1. LCD Status Messages
Code Text
E1000 Failsafe
voltage
error.
Contact
support.
E1114 Ambient Temp
exceeds
allowed
range.
E1116 Memory
disabled,
temp above
range. Power
cycle AC.
E1210 Motherboard
battery
failure.
Check
battery.
E1216 3.3V
Regulator
failure.
Reseat PCIe
cards.
24
About Your System
Causes
Check the system event log
for critical failure events.
Ambient temperature has
reached a point outside of
the allowed range.
Memory has exceeded
allowable temperature
and has been disabled
to prevent damage to
the components.
CMOS battery is missing
or the voltage is outside
of the allowable range.
3.3V voltage regulator
has failed.
Corrective Actions
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help" on
page 157.
See "Troubleshooting
System Cooling Problems"
on page 136.
Remove AC power to the
system for 10 seconds and
restart the system.
See "Troubleshooting
System Cooling Problems"
on page 136. If the problem
persists, see "Getting Help"
on page 157.
See "Troubleshooting the
System Battery" on
page 134.
Remove and reseat the
PCIe expansion cards.
If the problem persists,
see "Troubleshooting
Expansion Cards" on
page 143.