SDC QuietDuo LR100 Series Installation Instructions

SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
Retrofit Installation Note:
have the required space to fit the standard E. L. R. assembly. Always verify the distance from the end of the touchpad to
the end rail, and if necessary, consult with the factory for appropriate selection.
Step 1
Remove Von Duprin installed mechanical dogging assembly.
Step 2
Slide the LR100 Electric Latch Retraction assembly into device and attach the linkage to the latch retraction rod.
CLEVIS
CLEVIS PIN
P:\INST INSTRUCTIONS\ELR KITS\INST-LR100VDK
INSTALLATION INSTRUCTIONS
LR100VDK
ELECTRIC LATCH RETRACTION DEVICE KIT
MODELS: 3327A, 3348A,3527A, 3548A, 9827,
9847, 9849, 9857, 9927, 9947, 9949, 9957 & 9975
42" or 48" exit devices that have been modified to fit a 36" or smaller opening, may not
VON DUPRIN MECHANICAL
DOGGING ASSEMBLY
REV R 10-23
BACK LR100 OUT
UNTIL LINKAGE
JUST MAKES
CONTACT HERE
VON DUPRIN LATCH
RETRACTION ROD
LR100 LINKAGE
Page 1
ELECTRICAL DATA
24VDC +/- 10%
1.5A Inrush / 200mA holding
RED (+) BLK (-)
PATENT #8,851,530
* Visit: sdcsec.com/vonduprin
For Installation video
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email engineer@sdcsecurity.com