Advertisement
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
P:\INST INSTRUCTIONS\Electrical Devices\INST-S4100
INSTALLATION INSTRUCTIONS
PANIC / FIRE EXIT DEVICE
REV -
11-20
S4100
RIM
These instructions are presented in step by step sequence.
Use the provided templates to tape to your door and frame
as an aid to prepare in mounting the device.
Please read instructions thoroughly before installing.
Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email engineer@sdcsecurity.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SDC S4100
Summary of Contents for SDC S4100
- Page 1 Please read instructions thoroughly before installing. Any suggestions or comments to this instruction or product are welcome. Please contact us through P:\INST INSTRUCTIONS\Electrical Devices\INST-S4100 REV - 11-20 Page 1 our website or email engineer@sdcsecurity.com...
- Page 2 End Cap Device Body Panic Chassis Strike Rated Shim Strike Push Bar Latch Bolt Chassis Cover Fire Rated Strike DOOR HANDING Use this diagram to determine the Handing of Door Outside Inside P:\INST INSTRUCTIONS\Electrical Devices\INST-S4100 REV - 11-20 Page 2...
- Page 3 (51mm) NOTE: Use the Mullion Strike & Strike Hook instead of a standard Rim Strike if two Rim Fire Exit Devices are installed with the Fire Rated Mullion. P:\INST INSTRUCTIONS\Electrical Devices\INST-S4100 REV - 11-20 Page 3...
- Page 4 1. Remove End Cap from End Cap Bracket. Use the Template (or the End Cap Bracket) to mark hole locations. 2. Drill and tap two mounting holes and drill one wire through hole. Install the End Cap & End Cap Bracket. P:\INST INSTRUCTIONS\Electrical Devices\INST-S4100 REV -...
- Page 5 BLK (-) PATENT #8,851,530 KEY SWITCH ACCESS CONTROL POWER SUPPLY 2. Apply power to the ELR and cycle the unit to verify that it is retracting both the push pad and latch. P:\INST INSTRUCTIONS\Electrical Devices\INST-S4100 REV - 11-20 Page 5...
- Page 6 Providing constant power of 24VDC to the ELR will keep the push bar depressed and the latch retracted. Release Electric Dogging: De-energizing the ELR will release the push bar. The push bar will return to the detracted position and the latch will extend to lock door. P:\INST INSTRUCTIONS\Electrical Devices\INST-S4100 REV - 11-20 Page 6...
Need help?
Do you have a question about the S4100 and is the answer not in the manual?
Questions and answers