LG Code Zero S97 Series Manual page 17

How to use
Note about using the product
Points to be aware of when using the
product
Make sure that the dustbin lid is on prior to using the
•
product. Otherwise, the suction strength will deteriorate
and cleaning will not be satisfactory.
Support the bottom of the product when cleaning an
•
elevated surface.
When leaving the product unattended or unused for
•
an extended period, make sure to place it properly on
the charging station or lie it on the floor. Otherwise, the
product may fall and get damaged or cause an injury.
Make sure that the exhaust filter is properly assembled
•
before using the product.
Environmental conditions such as temperature and
•
humidity may cause static to accumulate on the product.
Please contact the customer service department of LG
Electronics if the problem persists.
Any foreign object on the inlet port or extension pipe will
•
prevent the product from functioning properly. Make sure
to remove any foreign object such as a sock or stocking
before using the product.
The battery runtime will be shortened after using the
•
product repeatedly for an extended period due to its
characteristics.
When the battery is about to become fully run down
•
during use, the last block on the battery indicator will
start to flash and the product will power off after a while.
Fully charge the battery in this case.
Please use the product at normal room temperatures as
•
the battery runtime will deteriorate severely if used at
temperatures lower than 5℃ or higher than 38℃ for an
extended period of time.
Refer to Product specifications for battery run time
•
details.
These times are a guide only and may be less depending
•
on the surface type.
It is recommended to swap the battery on the main body
•
and the battery on the auxiliary charging station regularly
for maintaining the maximum life of the batteries. (For
dual-battery models only)
Using the Product
1
Assemble the body, extension pipe, inlet port, and
battery in that order.
Inlet port
2
Press the button on the extension pipe to adjust its
length.
The pipe has 4 extendable length positions
•
Pipe length ex-
tension button
3
Attach the accessory tool to the body or the
extension pipe.
CAUTION
Prolonged use of the product with the accessory tool
•
attached may overburden the motor.
Using the inlet port to clean a TV, monitor or LCD display
•
may scratch the screen.
Exercise caution to avoid getting your finger stuck in any
•
gap when assembling the attachments.
If any foreign object is sucked into the inlet during
•
cleaning, operation of the vacuum cleaner might stop
in order to prevent damage to the body or motor.
Immediately stop using the vacuum cleaner and remove
the object before resuming cleaning.
Product
body
Battery
Extension pipe
Extension pipe
-17-