Page 13
Instruction Manual : Ver 1.01 TP-259 Land Nest Shelter...
Page 14
Thank you for purchasing a Snow Peak product. This product is a shelter. For safety, read the following instruction manual before use. Please keep it safe for future reference. Finally, if you find anything that you do not understand in the description or any problems with the product, please stop use immediately and contact the retailer or Snow Peak Customer Service.
Page 15
CAUTION: Misuse could result in injury to the user and/or damage to property. ●The text regarding caution will be included. ●This product is not intended to be in permanent use. If the shelter is left in the sun for long periods, the materials may fade in color, or the fabric may deteriorate and lose strength.
Page 16
各部の名称 Instructions for Use Setup Procedure Follow the instructions below to practice setting up and packing up this product several times in order to prepare yourself for the actual camping. Check in advance that all accessories are supplied. Inadequate setup and packing up may result in damage to the main unit or the frames and further lead to accidents.
Page 17
Extend the center frame and the two A frames, and then firmly join the connecting parts. * Firmly insert the parts so that no gap is present in the connecting parts of the frame. Center frame Firmly join the connecting parts A frame Check the part marked ...
Page 18
Hook the center ring on the protruding ridge pole. Center ring Insert the tip of the A frame into the ring pin on the main unit side. (2 locations) Gray loop Insert the other A frame into the center frame in the same way as described in step ⑥. While bowing the center frame as shown in the illustration below, insert one of the tips of the A frame into the ring pin on the main unit side.
Page 19
While gently pulling up the entire frame, pull the ring pin toward you. Insert the other tip of the A frame into the ring pin on the main unit side. * Adjust the sleeve so that it comes to the center of the ridge pole when the frame stands up. Extend the two C frames and then firmly join the connecting parts.
Page 20
After passing the frame through the sleeve, insert the tip of the C frame into the ring pin on the outer side. Insert the other tip of the C frame the same way. Gray loop Following the same procedure from step , attach the other C frame to the ring pin on the outer ⑪...
Page 21
Extend the ropes and drive the pegs. Attaching the rope with ring Peg down in the position perpendicular to the base of the triangle door panel Frame 2.5m 2.5m Sewn part 3.5m 3.5m Peg down Peg down diagonally diagonally Ring Ring Wind the tape around the frame, and pass it through the tape before the sewn...
Page 22
Attaching the Inner Tent Spread the inner tent inside the shelter while making sure that the orientation is correct. The side with the logo printed on the bottom faces the inside. * The fly sheet itself does not have a front or back side. Logo print Attach the plastic hooks of the inner tent to the plastic rings inside the fly sheet.
Page 23
Snow Peak Customer Service. If there are apparent defects in the product's manufacturing, the defective product will be repaired or exchanged free of charge. In other cases, Snow Peak will repair the product for an appropriate fee. The decision to repair or replace the product will be at our discretion.
●Transportation and repair costs are determined as follows. 1.Within warranty: The transportation cost (both ways) and repair cost will be covered by Snow Peak. 2.Outside warranty: The transportation cost (both ways) and repair cost will be covered by the customer.
Need help?
Do you have a question about the TP-259 and is the answer not in the manual?
Questions and answers