Installing an AGP Card
Follow the instructions in "Before You Begin" on page 68.
1
Open the computer cover (see page 70).
2
Press the lever on the card retention arm and raise the retention arm.
3
retention arm
Gently press the card into the AGP connector until it clicks into place, ensuring that the tab
4
fits into the notch on the front end of the card.
Lower the retention arm and press it into place, securing the card(s) in the computer.
5
Close the computer cover (see page 102).
6
Connect the monitor cable to the card's video connector.
7
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
Connect your computer and devices to electrical outlets, and turn them on.
8
Drives
Overview
Your computer supports one floppy drive and a combination of up to four of the following:
•
Either two IDE hard drives or two Serial ATA hard drives.
•
Two CD or DVD drives.
AGP card
lever
edge connector
AGP connector
PCI connector
Removing and Installing Parts
81