Table of Contents
Advertisement
Remove the processor from the socket.
6
If you are replacing the processor, leave the release lever extended in the release position so
that the socket is ready for the new processor and go to "Installing the Processor" on page 93.
Replace the airflow shroud (see page 92).
7
Close the computer cover (see page 102).
8
NOTICE:
the computer.
Connect your computer and devices to electrical outlets, and turn them on.
9
Front Panel
CAUTION:
page 9.
Removing the Front Panel
Follow the instructions in "Before You Begin" on page 68.
1
Open the computer cover (see page 70).
2
Disconnect and remove all disk drives (see "Drives" on page 81).
3
Release the front panel by pressing each of the front-panel release tabs.
4
There are seven release tabs.
96
Removing and Installing Parts
To connect a network cable, first plug the cable into the network wall jack and then plug it into
Before you begin any of the procedures in this section, follow the safety instructions on
release lever
processor
socket
Advertisement
Table of Contents
