System Board Components
hard-drive connector (PRI_IDE)
secondary drive connector (SEC_IDE)
floppy-drive connector (FDD)
memory module
connectors (2, 4)
power connector
(PWR)
memory module
connectors (1, 3)
processor and heat-
sink connector
(CPU_PIN_#_A1)
rear fan connector
(REAR_FAN2)
rear fan connector
(REAR_FAN1)
Memory
You can increase your computer memory by installing memory modules on the system board. For
information on the type of memory supported by your computer, see "Memory" on page 105.
NOTE:
DDR 333 memory operates at 320-MHz when used with an 800-MHz front-side bus processor.
password jumper (PASS)
battery socket
(BATTERY)
SCSI_LED header (SCSI_LED)
front-panel connector
(FRONT_PANEL)
standby power light
(PWR_LED)
serial ATA connector
(SATA_1)
internal speaker (SPKR)
clear CMOS jumper
(CMOS)
front fan (FRONT_FAN)
serial ATA connector
(SATA_0)
AGP card connector
(AGP)
PCI card connectors
(PCI_SLOT_1, PCI_SLOT_2,
PCI_SLOT_3, PCI_SLOT_4)
power connector (12V_PWR)
Removing and Installing Parts
73