Related Manuals for Wilo Initial DRAIN
Summary of Contents for Wilo Initial DRAIN
- Page 1 Pioneering for You Wilo-Initial DRAIN & WASTE en Installation and operating instructions · 6097589 • Ed.01/2025-02...
- Page 2 Initial DRAIN https.//qr.wilo.com/407 Initial WASTE https.//qr.wilo.com/408...
- Page 3 Fig. 1: Product overview Initial DRAIN and Initial WASTE Initial DRAIN Initial WASTE Fig. 2: Stationary wet installation Fig. 3: Transportable wet installation OFF2 min. WxL Initial DRAIN Initial WASTE Initial DRAIN Initial WASTE 380 mm (15 in) 430 mm (17 in) 380 mm (15 in) 430 mm (17 in)
- Page 4 9 Cleaning .................. 9 Cleaning the pump ............... 9 10 Maintenance................ 9 11 Faults, causes and remedies ............ 9 12 Disposal.................. 9 12.1 Information on the collection of used electrical and elec- tronic products.............. 9 Installation and operating instructions • Wilo-Initial DRAIN & WASTE • Ed.01/2025-02...
-
Page 5: Product Description And Function
Danger of death because of electric shock Submersible pump for transportable wet installation in intermit- tent operation. Fig. 1: Product overview Initial DRAIN and Initial WASTE – see Page Danger of death because of explosion Handle Danger because of bacterial infection Hose nozzle (included at Initial DRAIN) Connection size: Ø24 mm;... -
Page 6: Transportation And Storage
• Viscous fluids (e.g., oil and grease) • Make sure that the discharge line is installed frost-proof. • Sea water • Seal the pipe connections with Teflon band. Installation and operating instructions • Wilo-Initial DRAIN & WASTE • Ed.01/2025-02... - Page 7 Single-phase AC design: connect the pump to a ✓ Pipe clamp (diameter: 25 to 50 mm/1 to 2 in) for fastening the switchgear pressure hose at the hose nozzle. Screw the hose nozzle (included at Initial DRAIN) fully into the Switchgear specification discharge port. • Earth connection Connect the protective earth conductor of the switchgear to Put the pipe clamp over the pressure hose.
- Page 8 The gate valve in the discharge line is open. after shutdown. ✓ A water source with clean water is available to simulate the in- Close all shut-off valves. flow of water. Switch off the pump. Installation and operating instructions • Wilo-Initial DRAIN & WASTE • Ed.01/2025-02...
-
Page 9: Maintenance
A general overhaul is necessary after 2000 hours of operation. electronic products Contact customer service for maintenance. To prevent damage to the environment and human health, make sure to dispose of and recycle this product correctly. Installation and operating instructions • Wilo-Initial DRAIN & WASTE • Ed.01/2025-02... - Page 10 • Obey local regulations. Consult your local municipality, the nearest waste disposal site, or your retailer for a correct disposal. See for more http://www.wilo-recycling.com information about recycling. Installation and operating instructions • Wilo-Initial DRAIN & WASTE • Ed.01/2025-02...
- Page 12 Local contact at www.wilo.com/contact WILO SE Wilopark 1 44263 Dortmund Germany T +49 (0)231 4102-0 T +49 (0)231 4102-7363 wilo@wilo.com Pioneering for You www.wilo.com...
Need help?
Do you have a question about the Initial DRAIN and is the answer not in the manual?
Questions and answers