Minolta DIMAGE RD 3000 - SOFTWARE Manual page 109

USING THE CAMERA PANEL
NOTE:
The Dimâge RD 3000 is configured so that the shutter will not release unless the camera is in focus.
When you click the Capture button, your PC will send a release signal to the Dimâge RD 3000 for
approximately 20 seconds. During this time, a picture will be taken when the subject comes into focus
(Or, during flash photography, when the flash has recharged).
If during that 20-second interval, the camera is unable to focus or the flash does not recharge, no
picture is taken. In which event, a "Shutter was not Released" error message is displayed. Click the OK
button to close the error message dialog box, and return the program to stand-by status.
109