Contents turing flaw is the cause. In a warranty case, please con- tact your dealer (with the purchase receipt) or the next Intended use............authorised customer service site. Environmental protection........(See overleaf for the address) Accessories and spare parts ....... Further warranty information (if available) can be found in the service area of your local Kärcher website under Scope of delivery ..........
Charger ant hazards involved. ● Children must not play with the appliance. ● Children must be supervised to prevent DANGER ● Never touch the mains plug and them from playing with the appliance. ● Keep the device socket with wet hands. ● Do not charge the battery pack out of the reach of children when it is connected to the in an explosion-hazard environment.
Description of the device ● Connection to the Kärcher online shop, e.g. for pur- chasing additional accessories For the illustrations, refer to the graphics page. Connecting the device to the Kärcher Home & Gar- Illustration A den app: Right selection button 1.
Filling the fresh water tank speed and the amount of water are increased. Let the device slide slowly across the floor without ex- 1. Grasp the fresh water tank by the recessed grips at erting pressure on the device. the side and remove it from the device. Illustration Q 2.
Note 1. Press the ON / OFF button. The setting of Cleaning mode 1 or Cleaning mode 2 de- The device switches off. pends on the surface to be cleaned (e.g. wood or stone 2. Press the unlocking button for the waste water tank floor).
1. Place the empty waste water tank in the cleaning onds. During this time the device is silent. Only at the station to dry. end of the rinsing process do the rollers start to turn for a Place the device on the parking station and let it approx.
Do not use fabric softener when cleaning in a washing 5. Remove stuck dirt, e.gin the filter comb, with the machine. cleaning brush. Do not dry the rollers in a clothes dryer. Illustration AE Illustration AF ATTENTION 6. Insert the hair filters into the floor head and allow Material damage due to loose rollers them to latch into place.
Page 15
Fault Cause Rectification The warning "full tank" If detergents from other manufacturers 1. Use only KÄRCHER detergents and en- appears even though the are used or if too much detergent is used, sure the correct dosage. waste water tank is either a lot of foam may form in the waste water empty or not full tank, causing the volume of 200 ml in the...
Page 16
Fault Cause Rectification Rollers do not rotate and The device has a motor blockage, 1. Switch the device off and on. error message "blocked e.g.due to excessive pressure on the roll- rollers" appears ers or through movement into a wall/cor- ner.
Page 17
Fault Cause Rectification The device does not pick The fresh water tank is not sitting proper- 1. Insert the fresh water tank so that it is firmly up the dirt ly in the device. seated in the device. The waste water tank is missing or not 1.
Page 18
Fault Cause Rectification Poor cleaning result Rollers were not washed before first use. 1. Wash rollers at 60 °C in the washing ma- chine. The rollers are dirty. 1. Clean the rollers. The rollers are not sufficiently moistened. 1. Moisten the rollers. a Activate the Boost mode, see General information on operation.
Technical data FC 8 Electrical connection Voltage 100 - Phase Frequency 50 - 60 Degree of protection IPX4 Device protection class Charger protection class Nominal power of device Nominal voltage of battery 25,20 - 25,55 Battery type Li-ion Operating time when battery is ful- ly charged Charging time for an empty bat- tery...
Page 20
THANK YOU! MERCI! DANKE! ¡ GRACIAS! Registrieren Sie Ihr Produkt und profitieren Sie von vielen Vorteilen. Register your product and benefit from many advantages. Enregistrez votre produit et bénéficier de nombreux avantages. Registre su producto y aproveche de muchas ventajas. www.kaercher.com/welcome Bewerten Sie Ihr Produkt und sagen Sie uns Ihre Meinung.
Need help?
Do you have a question about the FC 8 Smart Signature Line and is the answer not in the manual?
Questions and answers