Belkin F5D8232-4 User Manual page 15

Knowing your N1 Vision
E. Connections to Wired Computers — Gray Ports – Connect
your wired (non-wireless) computers to these ports. These
ports are RJ45, 10/100/1000 auto-negotiation, auto-uplinking
ports for standard UTP category 5 or 6 Ethernet cable. The
ports are labeled 1 through 4. Use the gray cable provided
to connect your computer to any one of these ports.
F. Connection to Modem — Yellow Port – This port is for connection
to your cable or DSL modem. Use the cable that was provided with
your modem to connect the modem to this port. Use of a cable other
than the one supplied with the cable modem may not work properly.
G. Reset Button – The "Reset" button is used in rare cases when
the N1 Vision may function improperly. Resetting the N1 Vision
will restore the N1 Vision's normal operation while maintaining the
programmed settings. You can also restore the factory default
settings by using the "Reset" button. Use the restore option in
instances where you may have forgotten your custom password.
i. Resetting the N1 Vision – Push and release the "Reset"
button. The lights on the N1 Vision will momentarily flash. The
"Power/Ready" light will begin to blink. When the "Power/
Ready" light becomes solid again, the reset is complete.
ii. Restoring the Factory Defaults – Press and hold the
"Reset" button for at least 10 seconds, then release it. The
lights on the N1 Vision will momentarily flash. The "Power/
Ready" light will begin to blink. When the "Power/Ready"
light becomes solid again, the restore is complete.
H. Power Jack — Black – Connect the included
12V/1.25A DC power supply to this jack.
13
1
2
3
4
5
6
7
8
9
10