SPORTS HAWK Sports Hawk 105mm EDF, ARF+ KIT CONTENTS: 1. Main Fuselage 2. Nose Section 3. Left Wing 4. Right Wing 5. Left All-Flying Stab 6. Right All-Flying Stab 7. Ver tical Stab 8. Accessor y Pack 9. Screw Set 10.
Page 3
SPORTS HAWK KIT CONTENTS: Wi n g s p a n : 1500m m ( 59. 1" ) Len g t h: 1753m m ( 69" ) C o n t ro l s : A ile r o ns/ E le v a to r / Ru d d e r - N o se w h e e l/ F la p s/ Re tr a c ts...
Page 4
SPORTS HAWK ASSEMBLY Nose Fuselage Installation 1. Attach the nose section to the main fuselage using the 4 supplied M4x50mm machine screws as shown in the drawing. 4.0x50mm/4PCS WARNING Do not overtighten screws or damage may occur. 2. Glue the pitot tube and disturbed airflow generators to the nose section...
Page 5
SPORTS HAWK 3. Attach the Canopy to the Main Fuselage. Main Wing Installation 4. Slide the main wing joining spar through the slot in the fuselage. Then slide both wing panels onto the spar until they are snug against the fuselage wing roots, please ensure the multi-pin connectors align correctly and plug together.
Page 6
SPORTS HAWK Horizontal Stabilizer Installation 5. Slide the left and right all-flying stabilizers/elevators onto the spar protruding from the rear of the fuselage. Please ensure both line up as per the red line on the drawing below. Secure the left and right all-flying stabilizers/elevators to the...
Page 7
SPORTS HAWK Rudder Installation 6. Slide the vertical stabilizer joining spar into the slot in the top of the rear fuselage. Then slide the horizontal stabilizer onto the spar until it is snug with the fuselage horizontal stabilizer molding. M3x10mm/2PCS...
Page 8
SPORTS HAWK SPORTS HAWK 8. Glue in place the disturbed airflow generator to the side of the fuselage as shown below in the drawing.. 8A. Repeat this for the disturbed airflow generator on the other side.
Page 9
SPORTS HAWK WARNING: 1. Before switching on your transmitter and powering up the model for the first time, please move the flap channel control to its mid-flap position. 2. Then switch on your transmitter and power up the model, the flap servos should go to the mid-position.
Page 10
SPORTS HAWK SPORTS HAWK C OF G LOCATION The C of G should be between175mm and 180mm from the leading edge of the wing root as shown in the drawing. Carry out the check with the model inverted, the wheels retracted and the battery installed.
Page 11
SPORTS HAWK SERVO SPECIFICATIONS AND LAYOUT: 4 x 12g Digital Metal Gear servos. Operating voltage: 4.8v to 6.0v Torque: 1.3kg (45.85oz) @ 4.8v, 1.5kg (52.91oz) @ 6.0v 5 x 25g Digital Metal Gear servo. Operating voltage: 4.8v - 7.4v Aileron 25g Positive 505mm Torque: 4.45kg (158oz) @ 4.8v,...
Need help?
Do you have a question about the SPORTS HAWK and is the answer not in the manual?
Questions and answers