MODEL YACHT – ASSEMBLY INSTRUCTIONS & SAILING Remove the nut and washer from the shaft on the top of the keel HINTS and coat this shaft with petroleum jelly and carefully insert this Thank you for purchasing one of our range of model sailing yachts, shaft into the hole in the bottom of the hull (curved taper to the we hope it will bring you many hours of pleasure and relaxation.
Page 3
to avoid tearing the sail. The rudder should now be aligned with the centre line of the hull, Now fit the mast cap or top hat ensuring the long arm is on the once this is ok, put the sticker provided in place to cover and same side of the mast as the groove.
Page 4
Take the line from the back of the top hat to the fitting at the rear of the yacht and only lightly tighten at this stage. Then take the line at the top of the mainsail and thread it through the hole in the top hat, pull it quite tight and wind it around the turnbuckle just below.
Page 5
Now take the winch line on the front deck of the yacht and thread it To install the winch lines we need to power up the radio control through the fitting at the end of the front sail boom, thread it then equipment in order to put the sails in the right position.
Page 6
For medium wind (6-10MPH): Loosen the sails slightly in order to find The most efficient combination of sail shape and tension. As a rough guideline, you will want it somewhere in between the light and high wind set-up For high wind conditions (11- 15MPH): Loosen the front sail and main sail further.
operation before running the boat in water. In any case, you basically want the sails to be full of air and just on ·Total run time of the sailboat is approximately 45-60 minutes the verge of luffing. Here are some other terms that describe (assuming you begin with new batteries in the receiver box).
Need help?
Do you have a question about the Angel 920 and is the answer not in the manual?
Questions and answers