Akai LCT3226 Operating Instructions Manual page 42

■ Selecting Channel
Press CH+/- on the remote control to search the channels, the channel number will
increase or decrease by 1 for each pressing excluding the skipped channels.
Press number buttons 0~9 to select the corresponding channel content. If the
channel number is bigger than 9, just press the two number buttons successively. If
the channel number is bigger than 100, just press the three number buttons
successively. The time interval should not exceed 2 seconds.
If the channel number you pressed is bigger than the maximum channel number that
the setting is permitted, the maximum numbered channel content will be remained.
■ Channel Preview
Press RECALL button to switch between present channel and previous channel.
(Only for TV)
5 Using the Geometric Menu
Option
Contrast
Brightness
Back Light
Auto Setting
Phase
Manual Clock
Display
Adjustment
Note:
If your current input source is "VGA" or "DVI", push "MENU" enter into this menu. It
is not available in other input source mode.
"Auto Setting", "Phase", "Manual Clock" and "Display Adjustment" item can be adjust
when input source is "VGA".
■ Using Contrast
Press /
0~100 Reduce/Enhance
0~100 Darken/Brighten
Middle, Bright, Dark Adjust the balance of back light
To adjust the position of
display automatically
0~31 Soften/Sharpen
0~255 Decrease/Increase
Vertical position, To adjust the position of
Horizontal position display
Description
(Continued on next page)
41